Bosch Fuel Pump Module Assembly P/N:67617
Bosch 66120 fuel pump module for the 2012-2018 BMW 320i 4-cylinder 2.0L and other vehicles pumps fuel from inside the tank to the engine's injection system. This Bosch fuel pump module assembly is a self-priming electric unit that mounts in the tank.
Hard starting, sputtering or power loss under load, or a whine from the tank can mean a fuel pump assembly is wearing out. Before you replace it, rule out a blown fuse, a failed relay or a wiring fault, since any of them can also leave the engine cranking without starting. If the pump is the cause, this module takes its place.
As an in-tank electric pump, this module fits the 2013-2018 BMW 320i xDrive 4-cylinder 2.0L, the 2016-2018 BMW M2 6-cylinder 3.0L and other BMW models. Open the "Vehicles it fits" section to check your exact model and engine. Each car takes one module, mounted in the tank.
Fit and size
Build and materials
One fuel pump module with a strainer, fuel sending unit, regulator, fuel filter and O-ring. Mounting hardware, a gasket or seal, a lock ring and a wiring harness are not included; the old pieces may not be reusable, so plan on new ones.
Interchange: 16117243975
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Bosch 66120 fit the 2012-2018 BMW 320i 4-cylinder 2.0L?
Yes. Bosch 66120 fits the 2012-2018 BMW 320i 4-cylinder 2.0L, with one module per car. Open the "Vehicles it fits" section to check other models and engines.
What comes with the Bosch fuel pump module?
The module comes with a strainer, fuel sending unit, regulator, fuel filter and O-ring. Mounting hardware, a gasket or seal, a lock ring and a wiring harness are not included.
What voltage and connector does the Bosch 66120 have?
Bosch 66120 runs on 12 V DC and has one square/rectangle connector with four blade terminals. The outlet is SAE type with an 11.1 mm outside diameter.
Does this fuel pump module have a filter?
Yes. The module has 2 layers of filtration to protect the pump from debris and fuel system contamination, and it comes with a strainer and a fuel filter.
Is this fuel pump module plug-and-play?
Yes, it is designed for simple plug-and-play installation. Mounting hardware, a seal and a lock ring are not included, so have those ready.
Published by the manufacturer of this part. Links open in a new tab.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.