Swap a worn rear right caliper for the A1 CARDONE remanufactured Brake Caliper 19-B2793, a disc brake caliper that uses hydraulic pressure to clamp the brake pads against the rotor and slow the wheel. It fits many vehicles, among them the 2003-2007 Nissan Murano, 2004-2009 Nissan Quest and 2003-2005 Nissan 350Z. See the "Vehicles it fits" section for the full list and engine details.
This is an unloaded caliper supplied with its mounting bracket, so brake pads are not included. CARDONE remanufactures each unit to strict quality and performance standards, fits it with new components, and pressure-tests 100% of its calipers.
- New EPDM seals: the rubber seals are replaced with new high-temperature EPDM rubber.
- Pistons: built to resist cracking and pitting and to handle heavy loads.
- New bleeder screw: designed for trouble-free bleeding and a positive seal.
- Protected finish: treated with a specially formulated rust inhibitor and kept in the original equipment finish. A plastic cap plug covers each brake port thread.
Depending on the application, new banjo bolts, washers, stainless steel hardware clips and mounting pins are also included. This A1 CARDONE caliper is a remanufactured original equipment part, and CARDONE states that its process cuts the energy and raw material needed to make a new part by 80%. It is sold individually, and replacing both rear calipers together is recommended for balanced braking.
Interchange: 44001AM800
Frequently Asked Questions
Will this work as a 2003-2005 Nissan 350Z brake caliper for the rear right wheel?
Yes. It is cataloged for the rear right position on the 2003-2005 Nissan 350Z, and the "Vehicles it fits" section shows the full application list.
Is this the right 2003-2007 Nissan Murano caliper for a 2007 model?
It is listed as a rear right caliper for the 2003-2007 Nissan Murano, which includes the 2007 model year. It also fits the 2004-2009 Nissan Quest.
Are brake pads included with this caliper?
No. This is an unloaded caliper, so pads are sold separately. It comes with the caliper mounting bracket, a new bleeder screw and a cap plug on each brake port thread.
What are signs a brake caliper may need replacing?
Common signs include brake fluid leaking at the caliper, a wheel that drags or runs hot, uneven pad wear, a pull to one side or a soft pedal. Diagnose the cause before replacing parts.
What should I know about installing it?
Fit it with the correct pads, then bleed the brake system through the new bleeder screw. Follow the vehicle service information for torque values and whether the original fasteners may be reused.
