A1 CARDONE 31-74440 distributor for the 1991-1995 Toyota Previa 4-cylinder 2.4L sends voltage to the spark plugs in the correct timing pattern. This A1 CARDONE distributor is remanufactured under stringent quality standards.
- All electronic module components are 100% computer tested
- Components with consistently high failure rates are 100% replaced or repaired
- Precise machining tolerances help prevent oil leakage, poor timing and premature failure
- Automated tests check signal strength, harness polarity, air gap, crank reluctor tooth size, and coil and pickup performance
- 100% new points and condensers installed where applicable
Quick facts
- Part: A1 CARDONE 31-74440 distributor
- Fits: 1991-1995 Toyota Previa 4-cylinder 2.4L
- Material: aluminum housing, steel shaft
- Condition: Remanufactured
Hard starting, a misfire or poor timing can mean the distributor is worn, though worn spark plug wires or the ignition coil can be behind the same signs, so find the cause before replacing it.
Fits
It fits the 1991-1995 Toyota Previa 4-cylinder 2.4L, and the engine takes one.
Specifications
Fit and size
- Quantity per vehicle: 1
- Shaft diameter: 9.98 mm (0.393 in)
- Shaft length: 97.79 mm (3.85 in)
- Terminals: 4, male blade
- Rotor rotation: clockwise
Build and materials
- Type: electronic, magnetic coil trigger
- Vacuum advance: computer controlled
- Housing material: aluminum
- Shaft material: steel
- Connector type: unsealed
- Condition: Remanufactured
- Country of origin: Mexico
In the box
One distributor and one instruction sheet. The distributor cap, ignition rotor and coil wire are not included.
Interchange: 1910076010 · 1910076030
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Will this Previa distributor fit the 1991-1995 Toyota Previa 4-cylinder 2.4L?
Yes. A1 CARDONE 31-74440 is listed for the 1991-1995 Toyota Previa 4-cylinder 2.4L, and that engine takes one distributor.
Does the A1 CARDONE 31-74440 come with a distributor cap and rotor?
No. The box holds the distributor and an instruction sheet. The distributor cap, ignition rotor and coil wire are not included.
What size and material is the shaft on this remanufactured distributor?
The shaft is steel, 9.98 mm (0.393 in) in diameter and 97.79 mm (3.85 in) long. The housing is aluminum.
Is the electronic module on this remanufactured distributor tested?
Yes. All electronic module components are 100% computer tested, and automated equipment verifies signal strength, harness polarity, air gap, crank reluctor tooth size, and coil and pickup performance.
Does 1910076010 interchange with the A1 CARDONE 31-74440?
Yes. 1910076010 and 1910076030 are both listed as interchange numbers for A1 CARDONE 31-74440.
