A1 CARDONE 40-440 front windshield wiper motor for the 1993-1997 Dodge Intrepid and other vehicles drives the front wipers across the glass. This remanufactured A1 CARDONE windshield wiper motor is re-engineered, built and tested to match O.E. performance.
- Main components (armature, field, bearing, parking switch or pulse board) tested or gauged, then the finished motor function-tested on the vehicle
- Every motor bearing re-impregnated or replaced as needed
- Output gear lubricated for maximum load capacity and long life
- Weak solder points 100% reflowed to extend life expectancy
- Motor magnets 100% recharged for performance and reliability
Quick facts
- Part: A1 CARDONE 40-440 windshield wiper motor
- Fits: the 1993-1997 Dodge Intrepid and other vehicles
- Position: Front
- Material: Cast aluminum
- Condition: Remanufactured
Wipers that run slowly, stall or do not move at all can mean the motor is wearing out. These signs alone do not prove the motor is at fault, since a poor ground connection can also keep the wipers from running right.
Fits
The cars it fits include the 1993-1997 Dodge Intrepid, the 1993-1997 Chrysler Concorde and the 1993-1997 Chrysler Intrepid, and each takes one motor. If your car is something else, look up its year and model in the "Vehicles it fits" section.
Specifications
Fit and size
- Position: Front
- Quantity per vehicle: 1
- Mounting: direct bolt, 3 mounting holes
- Wiper speeds: 2
- Terminals: 4 male bullet terminals, 4 wires
- Connector: female
- Wiring harness length: 508 mm
Build and materials
- Condition: Remanufactured
- Material: Cast aluminum
- Country of origin: Mexico
In the box
One wiper motor with its wiring harness and an instruction sheet. A washer pump is not included.
Installation notes
- An instruction sheet comes with the motor.
- Some wiper motors will not run if the washer pump is defective, so bench test the wiper motor and the washer pump before replacing either.
Interchange: 4723419 · 4756018 · 4769121
Frequently Asked Questions
Is the A1 CARDONE 40-440 wiper motor right for a 1993-1997 Dodge Intrepid?
Yes, the A1 CARDONE 40-440 fits the 1993-1997 Dodge Intrepid, the 1993-1997 Chrysler Concorde and the 1993-1997 Chrysler Intrepid, and other cars are matched in the "Vehicles it fits" section.
Yes. A1 CARDONE 40-440 is listed for the 1993-1997 Chrysler Concorde, and each car takes one motor. For any other car, look up its year and model in the "Vehicles it fits" section.
Does this remanufactured wiper motor come with a wiring harness?
Yes, the A1 CARDONE 40-440 comes with a 508 mm wiring harness and an instruction sheet; the washer pump is not included.
Yes to the harness: the box holds the wiper motor with its wiring harness and an instruction sheet. No, a washer pump is not included.
Does the 40-440 come with a wiring harness, and is a washer pump included?
Yes, the A1 CARDONE 40-440 comes with a 508 mm wiring harness and an instruction sheet; the washer pump is not included.
Yes to the harness: the box holds the wiper motor with its wiring harness and an instruction sheet. No, a washer pump is not included.
How many speeds does the A1 CARDONE windshield wiper motor have?
Two speeds. The motor bolts on directly through three mounting holes and connects with four male bullet terminals.
This A1 CARDONE 40-440 wiper motor has 2 speeds. It has four wires and four male bullet terminals, plus a female connector.
How many speeds does this remanufactured wiper motor have?
Two speeds. The motor bolts on directly through three mounting holes and connects with four male bullet terminals.
This A1 CARDONE 40-440 wiper motor has 2 speeds. It has four wires and four male bullet terminals, plus a female connector.
Why does a wiper motor stop in the middle of the windshield?
A park switch inside the motor can be one reason, but the wiper arm or linkage can also leave the blades stopping mid-glass. A shop can test the motor before you replace it.
That can come from the motor's parking switch or pulse board, or from the wiper arm or linkage. A shop can test which one it is before you replace the motor.
Why does my front wiper motor stop in the middle of the windshield?
A park switch inside the motor can be one reason, but the wiper arm or linkage can also leave the blades stopping mid-glass. A shop can test the motor before you replace it.
That can come from the motor's parking switch or pulse board, or from the wiper arm or linkage. A shop can test which one it is before you replace the motor.
How is this remanufactured wiper motor tested?
Armature, field, bearing and parking switch or pulse board are tested or gauged against the O.E. standard, and the finished motor then goes through a function test on the vehicle.
On the A1 CARDONE 40-440, the armature, field, bearing and parking switch or pulse board are tested or gauged. Every motor bearing is re-impregnated or replaced as needed.
Which parts of this remanufactured wiper motor are tested or replaced?
Armature, field, bearing and parking switch or pulse board are tested or gauged against the O.E. standard, and the finished motor then goes through a function test on the vehicle.
On the A1 CARDONE 40-440, the armature, field, bearing and parking switch or pulse board are tested or gauged. Every motor bearing is re-impregnated or replaced as needed.
Frequently Asked Questions
Does the A1 CARDONE 40-440 fit the 1993-1997 Chrysler Concorde?
Yes, the A1 CARDONE 40-440 fits the 1993-1997 Dodge Intrepid, the 1993-1997 Chrysler Concorde and the 1993-1997 Chrysler Intrepid, and other cars are matched in the "Vehicles it fits" section.
Yes. A1 CARDONE 40-440 is listed for the 1993-1997 Chrysler Concorde, and each car takes one motor. For any other car, look up its year and model in the "Vehicles it fits" section.
Does this remanufactured wiper motor come with a wiring harness?
Yes, the A1 CARDONE 40-440 comes with a 508 mm wiring harness and an instruction sheet; the washer pump is not included.
Yes to the harness: the box holds the wiper motor with its wiring harness and an instruction sheet. No, a washer pump is not included.
Does the 40-440 come with a wiring harness, and is a washer pump included?
Yes, the A1 CARDONE 40-440 comes with a 508 mm wiring harness and an instruction sheet; the washer pump is not included.
Yes to the harness: the box holds the wiper motor with its wiring harness and an instruction sheet. No, a washer pump is not included.
How many speeds does the A1 CARDONE windshield wiper motor have?
Two speeds. The motor bolts on directly through three mounting holes and connects with four male bullet terminals.
This A1 CARDONE 40-440 wiper motor has 2 speeds. It has four wires and four male bullet terminals, plus a female connector.
How many speeds does this remanufactured wiper motor have?
Two speeds. The motor bolts on directly through three mounting holes and connects with four male bullet terminals.
This A1 CARDONE 40-440 wiper motor has 2 speeds. It has four wires and four male bullet terminals, plus a female connector.
Why does a wiper motor stop in the middle of the windshield?
A park switch inside the motor can be one reason, but the wiper arm or linkage can also leave the blades stopping mid-glass. A shop can test the motor before you replace it.
That can come from the motor's parking switch or pulse board, or from the wiper arm or linkage. A shop can test which one it is before you replace the motor.
Why does my front wiper motor stop in the middle of the windshield?
A park switch inside the motor can be one reason, but the wiper arm or linkage can also leave the blades stopping mid-glass. A shop can test the motor before you replace it.
That can come from the motor's parking switch or pulse board, or from the wiper arm or linkage. A shop can test which one it is before you replace the motor.
How is this remanufactured wiper motor tested?
Armature, field, bearing and parking switch or pulse board are tested or gauged against the O.E. standard, and the finished motor then goes through a function test on the vehicle.
On the A1 CARDONE 40-440, the armature, field, bearing and parking switch or pulse board are tested or gauged. Every motor bearing is re-impregnated or replaced as needed.
Which parts of this remanufactured wiper motor are tested or replaced?
Armature, field, bearing and parking switch or pulse board are tested or gauged against the O.E. standard, and the finished motor then goes through a function test on the vehicle.
On the A1 CARDONE 40-440, the armature, field, bearing and parking switch or pulse board are tested or gauged. Every motor bearing is re-impregnated or replaced as needed.
