Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251214
$176.99
(You save)
Keep the front-end geometry tight and the wheel properly located with the Mevotech TTX control arm, a front right lower Suspension Control Arm and Ball Joint Assembly (MPN CTXMS251214) that installs as a direct-fit replacement for the 2015-2022 RAM ProMaster City. This TTX lower control arm and ball joint assembly locates the steering knuckle and allows the suspension to travel while its integrated ball joint pivots for steering.
Mevotech TTX parts are engineered for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks, and Labor Saver designs help speed up the install.
Maximum toughness: patented sintered bearings for longer-lasting performance.
Increased stiffness: bushings upgraded with a double-bonded, solid cross section for added stiffness and durability.
Simple to service: includes a 90-degree SAE grease fitting.
Larger sphere design: an application-specific ball stud system with a larger sphere.
Fasteners included: an application-specific pinch bolt and locking nut are provided.
Stamped steel construction built to OE-level tolerances, with Repel-TEK surface treatment that helps resist rust build-up.
Interchange: 19531537 · 68263229AA
This part cross-references / interchanges with the following part numbers:
19531537, 68263229AA, CTXMS251214
Frequently Asked Questions
Will this Mevotech TTX control arm fit my vehicle?
It's a direct-fit replacement for the 2015-2022 RAM ProMaster City. Check the Buyer's Guide tab to confirm your exact configuration before ordering.
What position does this control arm cover?
This is the front right lower control arm, with the ball joint integrated into the assembly.
Does it include fasteners and a grease fitting?
Yes — an application-specific pinch bolt and locking nut are provided, along with a 90-degree SAE grease fitting. Consult the vehicle service information for the correct torque specs.
What are signs my control arm or ball joint may need replacing?
Clunking from the front suspension, loose or wandering steering, and uneven tire wear can be signs. Diagnose the cause before replacing, since these symptoms can have other sources.
What is this control arm made of?
It uses stamped steel construction with a Repel-TEK surface treatment that helps resist rust build-up.
Write a Review
MEVOTECH
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251214
Replace a worn Nissan Sentra control arm with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXMS301124), a front left lower unit that locates the wheel and lets the suspension...
Suspension Control Arm and Ball Joint AssemblyMevotech TTX™ parts are engineered with cutting-edge technology to be the strongest, most durable parts on the market. Built for high-usage commercial...
Tighten up your steering and keep the wheel firmly located with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXMS401281 — a direct-fit Ford Escape control arm that installs in the...
Locate the front wheel and keep steering tight with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXMS251235, a direct-fit front left upper Jeep Grand Cherokee control arm that...
Firm up your front end with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXMS401108 — a direct-fit Ford Escape control arm for the 2013-2019 Ford Escape. This unit mounts in the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
