Delphi FE0235 electric fuel pump for the 1991-2002 Saturn SL 4-cylinder 1.9L and other vehicles delivers fuel from the tank to the engine.
- Delphi electric fuel pump with an in-tank design
- Designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw puts less load on the vehicle's electrical system
- Helps restore fast pressure performance and system integrity with less energy
- Validated and tested for the vehicle application
Quick facts
- Part: Delphi FE0235 electric fuel pump
- Fits: the 1991-2002 Saturn SL 4-cylinder 1.9L and other vehicles
- Position: In-tank
- Condition: New
A weak pump can show up as hard starting, sputtering under load or stalling. Before you replace the pump, rule out a clogged fuel filter, a blown fuse or relay and damaged wiring, since any of them can produce similar symptoms.
Fits
This pump is listed for a wide range of Saturn models, including the 1991-2002 Saturn SL1 4-cylinder 1.9L and the 1991-2002 Saturn SL2 4-cylinder 1.9L, and each takes one pump. If your Saturn is not named here, look up your year and model in the "Vehicles it fits" section. The pump is built to Delphi's OE standards.
Specifications
- Position: In-tank
- Quantity per vehicle: 1
- Electrical connection: 2-wire harness with connector
- Condition: New
In the box
One electric fuel pump, isolator, seal, two splices, strainer adapter clip, washer, 2-wire harness with connector and instruction sheet.
Installation notes
- The instruction sheet in the box covers the installation steps.
- Check and clean the fuel tank as part of the job.
- Replace the fuel strainer whenever a fuel pump is repaired.
Frequently Asked Questions
Is the Delphi FE0235 the right electric fuel pump for a 1991-2002 Saturn SL1 4-cylinder 1.9L?
Yes. Delphi FE0235 is listed for the 1991-2002 Saturn SL1 4-cylinder 1.9L, and that car takes one pump.
Does the Delphi FE0235 come with a wiring harness and strainer adapter clip?
Yes. Delphi FE0235 comes with the pump, isolator, seal, two splices, strainer adapter clip, washer, a 2-wire harness with connector and an instruction sheet.
Is this an in-tank fuel pump?
Yes. This pump is an in-tank unit, so it sits inside the fuel tank. It connects through the 2-wire harness with connector that comes in the box.
Can a weak in-tank fuel pump make a car hard to start?
Hard starting can be a sign of a worn pump, along with sputtering or stalling. Have a shop test the fuel system rather than keep driving on a weak pump.
Should the fuel strainer be replaced along with this fuel pump?
Yes. Replace the strainer whenever you repair a fuel pump, and check and clean the fuel tank at the same time.
