Delphi FE0679 electric fuel pump for the 2007-2013 Mazda 3 4-cylinder 2.3L and other vehicles moves fuel from inside the tank to the engine.
- Designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw puts less load on the vehicle's electrical system
- Delphi pump design aimed at fast pressure performance and system integrity with less energy
- Validated, tested and matched to the right vehicle application
Quick facts
- Part: Delphi FE0679 electric fuel pump
- Fits: 2007-2013 Mazda 3 4-cylinder 2.3L and other vehicles
- Position: In-tank
- Condition: New
Hard starting, stalling or a whine from the tank can mean a fuel pump is wearing out. Before you replace this one, rule out a clogged fuel strainer, a blown fuse or relay and a wiring fault, since each of them can also leave the engine hard to start. One pump goes in the fuel tank.
Fits
This pump fits the 2007-2013 Mazda 3 4-cylinder 2.3L, the 2007-2012 Mazda CX-7 4-cylinder 2.3L and the 2006-2007 Mazda 6 4-cylinder 2.3L. Delphi builds all of its fuel pumps to its OE standards.
Specifications
- Position: in-tank
- Quantity per vehicle: 1
- Condition: new
In the box
One electric fuel pump, one retainer, one seal, one steel clip and one instruction sheet.
Installation notes
- Check and clean the fuel tank before installing the pump.
- Replace the fuel strainer whenever you do a fuel pump repair.
- The instruction sheet in the box covers the installation steps.
Interchange: L3M8-13-350B
CFE0679 · P76818 · SP1413 · SP1488
This part cross-references / interchanges with the following part numbers:
CFE0679, P76818, L3M8-13-350B, SP1413, SP1488
Frequently Asked Questions
Does the Delphi FE0679 fit the 2006-2007 Mazda 6 4-cylinder 2.3L?
Yes. Delphi FE0679 fits the 2006-2007 Mazda 6 4-cylinder 2.3L, and it also fits the 2007-2013 Mazda 3 4-cylinder 2.3L.
Does this Delphi electric fuel pump come with a retainer and seal?
Yes. Delphi FE0679 comes with the pump, a retainer, a seal, a steel clip and an instruction sheet.
Is the FE0679 an in-tank fuel pump?
Yes. This pump's position is in-tank, so it mounts inside the fuel tank, and one pump goes in each application.
Should I replace the fuel strainer when I install this fuel pump?
Yes. The fuel strainer should be replaced with any fuel pump repair, and the fuel tank should be checked and cleaned first.
Can I cross-reference SP1488 to this fuel pump?
Yes. SP1488 is listed as an interchange number for Delphi FE0679.
