Delphi Fuel Pump and Strainer Set P/N:FE0741
Delphi FE0152 fuel pump and strainer set for the 1995 BMW M3 6-cylinder 3.0L, the 1996-1999 M3 6-cylinder 3.2L and other vehicles moves fuel from the tank to the engine. This Delphi fuel pump is built to Delphi's OE standards, and the set adds a fuel strainer because the strainer should be replaced whenever the pump is repaired.
Hard starting, stalling or a whine from the tank can mean the pump is wearing out. These signs alone do not prove the pump is at fault, since a clogged fuel filter can cause them too. If a worn pump is the cause, this Delphi fuel pump replacement replaces it.
It also fits the 1996-1999 BMW 328i 6-cylinder 2.8L and the 1996-1999 328is 6-cylinder 2.8L, along with more BMW models. The part is validated, tested and matched to the right vehicle application. A 1996-1999 328i 6-cylinder 2.8L takes one set, and this listing is one set. If your BMW is not named here, look up its year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One fuel pump and strainer set with an attached mounting bracket, a hose, a clamp and an instruction sheet.
Interchange: 16 14 1 180 504 · 16 14 1 182 842 · 16 14 1 182 985 · 16 14 1 183 139 · 16 14 6 758 736 · 152-0854 · 152-0954 · 152-0967
EP283 · EP434 · 4020282 · E8233 · CFE0152 · F4244 · P95172E · 69497 · P72185 · AFS0734P · E16132 · SP1237 · SP5085M · USEP8233
This part cross-references / interchanges with the following part numbers:
Is this the BMW 328i fuel pump for the 1996-1999 328i 6-cylinder 2.8L?
Yes. Delphi FE0152 fits the 1996-1999 BMW 328i 6-cylinder 2.8L and takes one set. For another BMW, look up its year and engine in the "Vehicles it fits" section.
Is a mounting bracket included with this Delphi fuel pump assembly?
Yes. Delphi FE0152 comes with an attached mounting bracket, a hose, a clamp and an instruction sheet, along with the pump and strainer.
Does Delphi FE0152 cross-reference to EP283?
Yes. EP283 is one of the cross-reference numbers for Delphi FE0152, printed with the other interchange numbers at the bottom of this page.
How can I tell if the fuel pump in this set is going bad?
Hard starting, stalling or a whine from the tank can mean a weak pump. A shop can test fuel pressure to confirm.
Do I need to replace the fuel strainer when changing this fuel pump?
Yes. The strainer should be replaced any time the pump is repaired, and this set already includes one. Check and clean the fuel tank at the same time.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.