Delphi HP10081 fuel pump and sender assembly for the 1999-2004 Ford F-53 Motorhome Chassis V10 6.8L and other vehicles holds the pump and float arm inside the fuel tank. The Delphi fuel pump, built to Delphi's OE standards, mounts on a fuel pump hanger assembly with metal tubes and a float arm whose empty height and retention match OE specifications.
- Delphi pump designed to operate under extreme temperatures with quick engine starts
- Metal tubes routed so they never contact the tank, avoiding noise and vibration during vehicle operation
- Fast pressure performance and system integrity with less energy use
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated and tested for its application
Quick facts
- Part: Delphi HP10081 fuel pump and sender assembly
- Fits: 1999-2004 Ford F-53 Motorhome Chassis V10 6.8L and other vehicles
- Condition: New
Hard starting, a fuel gauge that reads wrong or a whine from the tank can mean the pump or float is worn, though other fuel-system faults cause the same signs. Before replacing it, look at the pump fuse and relay with the key off, and leave fuel pressure testing to a shop.
Fits
This assembly fits Ford vans and motorhome chassis, including the 2003 Ford E-350 Club Wagon V8 5.4L or V10 6.8L and the 2003 Ford E-450 Super Duty V8 5.4L or V10 6.8L. The 2003 Ford E-450 Super Duty V8 5.4L or V10 6.8L takes one. If your van or chassis is not named here, enter its year and engine in the "Vehicles it fits" section to see whether it is covered.
Specifications
- Quantity per vehicle: 1
- Type: fuel pump hanger assembly with float arm
- Condition: New
In the box
One fuel pump and sender assembly with float arm, one seal, seven nuts, seven washers, two retainer clips and an instruction sheet.
Installation notes
- An instruction sheet comes with the assembly for the installation steps.
- Check and clean the fuel tank during installation.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this a Ford E-450 Super Duty fuel pump for the 2003 model with the V8 5.4L or V10 6.8L?
Yes. Delphi HP10081 fits the 2003 Ford E-450 Super Duty with either the V8 5.4L or the V10 6.8L, and each vehicle takes one.
Does this Delphi fuel pump assembly come with the seal, nuts and retainer clips?
Yes. The box holds the hanger with float arm, a seal, seven nuts, seven washers, two retainer clips and an instruction sheet.
Will the float on this assembly give a correct gas gauge reading?
Yes. On Delphi HP10081, the empty float height and float retention match OE specifications for a correct gas gauge reading.
Do the metal tubes on this assembly rub against the fuel tank?
No. The metal tubes are routed so they do not contact the tank at any point, which avoids noise and vibration while the vehicle is running.
Should I clean the tank when I fit a Delphi fuel pump replacement?
Yes. Check and clean the fuel tank during installation. This assembly comes with an instruction sheet for the installation steps.
