Delphi HP10220 fuel pump and sender assembly for the 1998 Ford Ranger 4-cylinder 2.5L, V6 3.0L or 4.0L moves fuel from the tank to the engine and reads the fuel level for the gauge. This Delphi fuel pump hanger assembly is built to Delphi's OE standards and carries the float arm.
- Designed to operate in extreme temperatures with quick engine starts
- Metal tubes routed so they never touch the tank, which removes noise and vibration during vehicle operation
- Empty float height and float retention set for correct gas gauge reading
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated and tested, then matched to the right application
Quick facts
- Part: Delphi HP10220 fuel pump and sender assembly
- Fits: 1998 Ford Ranger 4-cylinder 2.5L, V6 3.0L or 4.0L
- Condition: New
Hard starting, stalling or a fuel gauge that reads wrong can be signs of a worn pump or float, though a fuse, relay or wiring fault can look the same. Before you replace the assembly, rule out those and a dirty fuel tank; a shop can test fuel pressure.
Fits
It is a direct-fit replacement fuel pump for the 1998 Ford Ranger 4-cylinder 2.5L, V6 3.0L or 4.0L.
Specifications
Fit and size
- Quantity per vehicle: 1
- Quantity per listing: 1
Build and materials
- Construction: pump hanger assembly with float arm
- Hardware: seal and two retainer clips included
- Condition: New
In the box
One fuel pump and sender assembly with float arm, seal, two retainer clips and an instruction sheet. This listing holds one assembly, and the 1998 Ford Ranger 4-cylinder 2.5L, V6 3.0L or 4.0L takes one.
Installation notes
- Check and clean the fuel tank before installing.
- An instruction sheet comes with the assembly.
Interchange: 950-0165 · 951-0016 · 953-4105 · F87Z 9H307-CA · F87Z 9H307-CB · PFS-83
4011063 · E2208S · E2471 · DHP10220 · F1219A · 67157 · 69128 · P74866S · C0058H · A30183 · E16006 · SP1113 · SP2208H · USEP2208S
This part cross-references / interchanges with the following part numbers:
4011063, E2208S, E2471, DHP10220, F1219A, 67157, 69128, P74866S, 950-0165, 951-0016, 953-4105, F87Z 9H307-CA, F87Z 9H307-CB, PFS-83, C0058H, A30183, E16006, SP1113, SP2208H, USEP2208S
Frequently Asked Questions
Will this fuel pump fit the 1998 Ford Ranger V6 4.0L?
Yes. Delphi HP10220 fits the 1998 Ford Ranger 4-cylinder 2.5L, V6 3.0L and V6 4.0L.
Does this Delphi fuel pump assembly come with the float arm and seal?
Yes. Delphi HP10220 comes with the float arm, a seal, two retainer clips and an instruction sheet.
How does the float on this Delphi Technologies fuel pump affect the gas gauge reading?
Empty float height and float retention are set to match OE specifications, which is meant to give a correct gas gauge reading.
Why does my gas gauge read wrong, and could the sender be the cause?
A wrong reading can come from the float or sender, but wiring or other parts can cause it too. If the float is faulty, this assembly replaces it.
Does the tank need any work before installing this fuel pump and sender assembly?
Check and clean the fuel tank before installing the assembly. An instruction sheet comes with it for the installation steps.
