Delphi FG1313 fuel pump module for the 2009-2010 Ford E-150 V8 4.6L or 5.4L and other vehicles carries fuel from the tank toward the engine. Delphi builds this fuel pump module, also called a fuel pump assembly, to its OE standards.
- Empty float height and float retention are set for a correct gas gauge reading
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated, tested and matched to the vehicle application it is sold for
- Design and durability aimed at lower failure rates
Quick facts
- Part: Delphi FG1313 fuel pump module
- Also called: fuel pump assembly
- Fits: 2009-2010 Ford E-150 V8 4.6L or 5.4L and other vehicles
- Condition: New
Hard starting, stalling or a gas gauge that reads wrong can mean the module is failing. Before you replace it, rule out the fuse, relay and wiring, since a fault there can look the same.
Fits
This fuel pump module is a direct-fit replacement for the 2009-2010 Ford E-250 V8 4.6L or 5.4L and the 2009-2010 Ford E-350 Super Duty V8 5.4L or V10 6.8L, among other vehicles. If your vehicle isn't one of these, look it up by year and engine in the "Vehicles it fits" section.
Specifications
- Quantity per vehicle: 1
- Condition: New
In the box
One fuel pump module with float arm, seal and instruction sheet. This listing holds one module, and each vehicle takes one.
Installation notes
- Check and clean the fuel tank before the new module goes in.
- The instruction sheet in the box covers the installation steps.
Interchange: 9C2Z 9H307-C · PFS-479
4010492 · 4010703 · E2527M · DFG1313 · P76459M · P76474M · AC2Z9H307E · C0126M · A30442 · A30446 · SP2376M · USEP2527M
This part cross-references / interchanges with the following part numbers:
4010492, 4010703, E2527M, DFG1313, P76459M, P76474M, 9C2Z 9H307-C, AC2Z9H307E, PFS-479, C0126M, A30442, A30446, SP2376M, USEP2527M
Frequently Asked Questions
Does the Delphi FG1313 fit a 2009-2010 Ford E-350 Super Duty V10 6.8L?
Yes. Delphi FG1313 is listed for the 2009-2010 Ford E-350 Super Duty with the V10 6.8L and with the V8 5.4L, at one module per vehicle.
What comes with the Delphi fuel pump module assembly?
This FG1313 listing is one fuel pump module with a float arm, a seal and an instruction sheet.
Does the Delphi fuel module match the original float height?
Yes. The empty float height and float retention match OE specifications and are meant to give a correct gas gauge reading.
Is the Delphi module tested for a specific vehicle?
Yes. This part is validated, tested and matched to the right vehicle application, and its lower amperage draw puts less load on the electrical system.
Do I need to clean the fuel tank when installing this fuel pump module?
Yes. The fuel tank should be checked and cleaned when the new module is installed.
