Dial in your steering geometry with the Delphi Steering Drag Link Adjusting Sleeve (TA6469), a threaded sleeve that joins the drag link components and lets a technician adjust the assembly's length to set the steering. It installs as a direct-fit replacement for the 2014-2018 RAM 2500 and the 2013-2018 RAM 3500 — see the Buyer's Guide tab for engine-level fitment.
Delphi builds this part on the same OE safety expertise fitted to millions of vehicles worldwide, backed by extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
If a worn or seized sleeve is behind loose or hard-to-adjust steering, this replaces it. Have the front end aligned after installation.
Interchange: 68111 302AA
68111302AA · DS800985S · MS250280 · JSA118
This part cross-references / interchanges with the following part numbers:
What does the drag link adjusting sleeve do?
It's a threaded sleeve that connects the drag link components and lets a technician adjust the assembly's length to set the steering geometry.
Does this fit my truck?
It's a direct-fit replacement for the 2014-2018 RAM 2500 and 2013-2018 RAM 3500. Check the Buyer's Guide tab to confirm the fit for your vehicle.
How is this Delphi part tested?
Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and fatigue-tests it to help guard against failure.
Does it come with what I need to install it?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for torque specs and the correct procedure.
Should I get an alignment after installing it?
Yes. Because this sleeve sets the drag link length, have the front end aligned after installation so the steering is properly set.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
