Right Outer Tie Rod End for 2007-2013 Volvo C30 & More - Delphi TA1990

Steer with confidence using the Delphi tie rod end (MPN TA1990), the right outer joint that links your steering to the wheel and helps keep toe alignment holding true. It installs as a direct-fit replacement on many Volvo models, among them the 2008-2011 Volvo C30, 2006-2011 Volvo C70 and 2004-2010 Volvo S40 — see the "Vehicles it fits" section for the full list and engine-level fitment.

• OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
• Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
• Precision ball stud: machined to micron tolerances for smooth joint operation, and fatigue tested to help avoid failure.
• Corrosion protected: anti-corrosion protection applied to each part; the necessary accessories are included for a complete job.

Worn tie rod ends can show up as loose or wandering steering, uneven tire wear, or a clunk when turning — if a failed right outer tie rod end is the cause, this replaces it. This listing is for the right outer joint; inspect the left side and have an alignment performed after installation.