Delphi TA2356 left outer tie rod end for the 2004-2011 Mazda RX-8 links the steering linkage to the steering knuckle. This Delphi tie rod, also called a steering tie rod end, passes steering input out to the wheel.
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Tie rod end fatigue tested to avoid failure
- Anti-corrosion protection applied to each part
- Tie rod end withstands temperatures below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray
Quick facts
- Part: Delphi TA2356 tie rod end
- Also called: steering tie rod end
- Fits: 2004-2011 Mazda RX-8
- Position: Left outer
- Condition: New
Loose or wandering steering, a clunk from the steering area or uneven tire wear can mean a tie rod end is worn. Worn ball joints, wheel bearings, struts or an alignment problem can produce the same signs, so pin down the real cause before you order.
Fits
It is a direct-fit replacement for the 2004-2011 Mazda RX-8. Both outer ends are normally replaced together as a pair. This listing is the left outer one only; the car takes one on each side, and the right outer end is a separate part.
Specifications
Fit and size
- Position: left outer
- Quantity per application: 1
Build and materials
- Condition: New
- Corrosion protection: anti-corrosion protection on each part
In the box
One left outer tie rod end with the accessories needed to install it.
Interchange: 101-5509 · MD-T216 · F151-32-290
531044 · ER11035 · KTR4369 · TO65171 · TO65171PR · ES800823 · ES4422 · MS76605 · JTE1877
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
101-5509, MD-T216, 531044, ER11035, KTR4369, TO65171, TO65171PR, ES800823, F151-32-290, ES4422, MS76605, JTE1877
Frequently Asked Questions
Does the Delphi TA2356 left outer tie rod end fit the 2004-2011 Mazda RX-8?
Yes. Delphi TA2356 is a left outer tie rod end for the 2004-2011 Mazda RX-8. The right outer end is a separate part.
How are the ball studs made on this Delphi tie rod end?
The ball studs on Delphi TA2356 are machined to micron tolerances, which supports durability and smooth joint operation. The tie rod end is also fatigue tested.
Is a Delphi track rod end the same as this tie rod end?
Yes. Track rod end is another name for a tie rod end. This one is the left outer unit, sold one per listing.
How can I tell this left outer tie rod end is worn?
Look for a cracked or torn boot, play in the joint with the engine off, or loose steering and uneven tire wear. A shop can check the joint safely.
Can Delphi TA2356 be used in place of part number 531044?
Yes. 531044 is one of the other-brand numbers that Delphi TA2356 replaces. All of them are on the Interchange line.
