Keep the steering linkage on your Mazda tight and precise with the Delphi tie rod (MPN TA2782), an inner steering tie rod end built with Delphi's OE safety technology. It fits the 2006-2015 Mazda MX-5 Miata — see the Buyer's Guide tab for the applicable engine details. As the inner joint that connects the steering rack to the tie rod assembly, it transmits steering input while allowing the linkage to pivot and articulate with suspension travel.
Delphi includes the necessary accessories for a complete job. Worn inner tie rod ends may show up as loose or wandering steering, uneven tire wear, or a clunk when turning; if the inner joint is the cause, this replaces it.
Interchange: 101-7646 · NE51-32-240
1017646 · NE5132240 · AX07227 · TI65100 · EV800713 · MS76716 · JAR1316
This part cross-references / interchanges with the following part numbers:
Does this Delphi tie rod end fit my Mazda MX-5 Miata?
Yes, TA2782 is a direct-fit inner steering tie rod end for the 2006-2015 Mazda MX-5 Miata. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this an inner or outer tie rod end?
This is the inner steering tie rod end, the joint that connects the steering rack to the tie rod assembly.
What does a Delphi tie rod end do?
It transmits steering input from the rack to the wheel while allowing the linkage to pivot and articulate as the suspension moves.
What are signs my inner tie rod end may need replacing?
Common signs include loose or wandering steering, uneven or accelerated tire wear, and a clunk when turning. Diagnose the cause before replacing.
Does it include the hardware needed for installation?
Delphi states it includes the necessary accessories for a complete job. Follow the vehicle service procedure for correct installation and torque.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
