Help tighten up sloppy steering with the Delphi tie rod that carries steering input from the linkage to the wheel — the Delphi Steering Tie Rod End TA2903 is a front inner tie rod end that drops in as a direct-fit replacement for the 2012 Volkswagen Passat and 2012 Volkswagen Beetle (see the "Vehicles it fits" section for engine details).
Delphi applies its OE steering expertise to this aftermarket unit, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Tested to the extreme: withstands temperatures below -40°C and above 120°C, plus 720 hours of salt-spray exposure.
- Precision ball stud: machined to micron tolerances for durability and smooth joint operation.
- Fatigue tested to help avoid premature failure.
- Anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
Delphi includes the necessary accessories for a complete job. If a worn inner tie rod end is behind your loose steering, play, clunking on turns, or uneven front-tire wear, this Delphi track rod end replaces it. Sold individually.
Interchange: 5Q0 423 810 · 101-7810 · 612.33076 · 561 423 810
5Q0423810 · 1017810 · 61233076 · 561423810 · KRE4063 · TI43125 · TI43125XL · EV800899 · GS10711 · MS10711 · JAR589
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
5Q0 423 810, 101-7810, 612.33076, KRE4063, TI43125, TI43125XL, EV800899, GS10711, MS10711, JAR589, 561 423 810
Frequently Asked Questions
Does this Delphi tie rod end fit a 2012 Volkswagen Passat?
Yes. It is listed as a direct-fit tie rod end for the 2012 Volkswagen Passat and the 2012 Volkswagen Beetle. Check the "Vehicles it fits" section to confirm your engine.
Is TA2903 a front inner tie rod end?
Yes, the catalog lists this part in the front inner position for the covered applications.
What's included with this Delphi tie rod?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for correct torque specs and any fasteners that may be single-use.
What are signs my tie rod end may need replacing?
Loose or wandering steering, play in the joint, clunking or knocking when turning, and uneven front-tire wear can be signs. Diagnose the cause before replacing, as other components can produce similar symptoms.
Are Delphi tie rods built to OE standards?
In our Delphi tie rod review of the specs, Delphi applies its OE steering expertise with micron-tolerance ball studs, fatigue testing, and dimensional analysis for close OE-to-aftermarket compatibility.
