Tie Rod End for 2018-2019 Hyundai Sonata & More - Delphi TA3361

Delphi TA3361 tie rod end for the 2018-2019 Hyundai Sonata and other vehicles is the left outer joint between the inner tie rod and the steering knuckle. This Delphi tie rod end passes steering input to the wheel.

• Tested for OE performance: withstands temperatures below -40 degrees C and over 120 degrees C and 720 hours of salt spray.
• Extensive dimensional and material analysis is used for compatibility between the OE and aftermarket part.
• Includes the necessary accessories for a complete job.
• Ball studs are machined to micron tolerances for durability and smooth joint operation.
• Delphi tie rods are fatigue tested to avoid failure.
• Anti-corrosion protection is applied to each part.

Play in the steering, a knock when turning or uneven tire wear can mean a worn joint. Those signs alone don't prove this part is the problem, since a worn control arm bushing can loosen the steering too. Replace the tie rod ends as a pair, one on each side of the axle; this listing is a single left outer one.

The 2020 Kia Optima and 2020-2022 Hyundai Palisade are also covered, along with more models. If your car isn't named here, find it in the "Vehicles it fits" section.

Specifications

• Position: left outer
• Quantity per application: 1
• Sold individually, one per listing

Interchange: 101-8407
56820G8000 · KTR4564 · MS90672

Product information is for general reference and may contain errors. See our Disclaimer.