Tie Rod End for 2019-2020 Ford Ranger - Delphi TA3614

Delphi TA3614 tie rod end for the 2019-2020 Ford Ranger is the left outer joint that passes steering input from the tie rod to the steering knuckle. Delphi applies its OE expertise to the part and uses dimensional and material analysis to match compatibility with the OE part.

• Withstands temperatures below -40 degrees C and over 120 degrees C
• Exposed to 720 hours of salt spray
• Ball stud machined to micron tolerances for durability and smooth joint operation
• Delphi tie rods are fatigue tested to avoid failure
• Anti-corrosion protection applied to each part

A worn steering tie rod end can come with play in the steering, uneven tire wear or a clunk when turning. These signs alone don't prove this part is the problem, since an out-of-spec alignment can feel much the same. This listing is a single left outer piece and the truck takes one on each side of the axle, so both sides are normally replaced together.

It is a direct-fit replacement for the left outer tie rod end on the 2019-2020 Ford Ranger.

Specifications

• Position: Left outer
• Pieces per listing: 1

In the box: the tie rod end and the accessories Delphi includes for a complete job.

Interchange: KB3Z-3A130-D
TO8652 · MS406112

Product information is for general reference and may contain errors. See our Disclaimer.