Tie Rod End for 2025 Audi RS e-tron GT Performance & More - Delphi TA3839

Delphi TA3839 tie rod end for the 2025 Audi RS e-tron GT Performance and other vehicles sits at the right outer position and passes steering input from the linkage to the wheel.

• Tested for OE performance: withstands temperatures below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray
• Dimensional and material analysis is used to match the OE part's compatibility
• The necessary accessories for a complete job are included
• Ball studs are machined to micron tolerances for durability and smooth joint operation
• Delphi tie rods are fatigue tested to avoid failure
• Anti-corrosion protection on each part, for corrosion prevention and a better finish

Looseness in the steering, a knock over bumps or uneven tire wear can mean this tie rod end is worn, though a worn ball joint or control arm bushing can be behind the same signs, so find the cause first. One goes on each side of the steering, and this listing is the right outer one only; the left side takes its own end, so fit the two together.

This Delphi steering tie rod end is a direct-fit replacement for the 2025 Audi S e-tron GT and the 2020-2025 Porsche Taycan. Open the "Vehicles it fits" section to check your exact model and engine.

Specifications

• Position: right outer
• Quantity per vehicle: 1
• Finish: anti-corrosion protection

Interchange: 9J1 423 812 A · 9J1 423 812 B
KTR4742 · MS70651 · X39TE0989