Delphi TA3873 tie rod end for the 2018-2026 Alfa Romeo Stelvio joins the steering linkage to the steering knuckle. It is a Delphi tie rod made for the front outer position.
- Built on Delphi's OE safety technology, which is fitted to millions of vehicles worldwide
- Tested to withstand temperatures below -40 degrees C and over 120 degrees C, and exposed to 720 hours of salt spray
- Dimensional and material analysis supports compatibility with the OE part
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Fatigue tested to avoid failure
- Anti-corrosion protection on each part
A worn steering tie rod end can show up as loose or wandering steering, a clunk from the front end or uneven front tire wear. Other worn front-end parts can produce similar symptoms, so pin down which part is at fault before you order. With the engine off, look at the old joint for a torn dust boot, leaking grease or rust, and leave play checks that need the car raised to a shop.
It is a direct-fit replacement for the 2018-2026 Alfa Romeo Stelvio, which takes two, one on each side of the front axle. This listing is one piece, and both sides are normally replaced together.
Specifications
Fit and size
- Position: front outer
- Quantity per vehicle: 2
Build and materials
- Ball studs: machined to micron tolerances
- Corrosion protection: anti-corrosion protection applied to each part
In the box
The necessary accessories for a complete job.
Interchange: 68365 396AA · 77368151 · 1018721 · KTR4343 · MS106256 · X03TE0595
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
68365 396AA, 77368151, 1018721, KTR4343, MS106256, X03TE0595
Frequently Asked Questions
Does the Delphi TA3873 fit the 2018-2026 Alfa Romeo Stelvio?
Yes, Delphi TA3873 is a front outer tie rod end for the 2018-2026 Alfa Romeo Stelvio. Each car takes two, one on each side.
Is the Delphi TA3873 a track rod end for the inner or outer position?
Delphi TA3873 is a front outer unit. Track rod end is another name for a tie rod end, so this one sits at the outer end of the steering linkage.
Beyond any Delphi tie rod review, what conditions was this front outer tie rod end tested in?
This tie rod end is tested at temperatures below -40 degrees C and over 120 degrees C, and exposed to 720 hours of salt spray.
How are the ball studs on this tie rod end made?
The ball studs are machined to micron tolerances for durability and smooth joint operation. The tie rod end is also fatigue tested to avoid failure.
What does a worn front outer tie rod end feel like?
Loose or wandering steering, a clunk from the front end or uneven front tire wear can be signs. A shop can check for play, which needs the car raised.
