Tie Rod End for 2019-2025 Nissan Altima - Delphi TA3992

Delphi TA3992 tie rod end for the 2019-2025 Nissan Altima is the joint at the outer end of the steering linkage, where the tie rod meets the steering knuckle so the wheel can turn as you steer.

• Tested for OE performance below -40 degrees C and over 120 degrees C, with 720 hours of salt spray exposure.
• Dimensional and material analysis supports compatibility between this part and the OE part.
• Includes the necessary accessories for a complete job.
• Ball studs are machined to micron tolerances for durability and smooth joint operation.
• Delphi tie rods are fatigue tested to avoid failure.

Uneven tire wear, loose or wandering steering, or a clunk when turning can mean an outer tie rod end is worn. A worn inner tie rod, a control arm bushing, a wheel bearing or an alignment problem can be behind these signs too, so find the cause before you buy. This listing is one piece, and both sides are normally replaced together. The Altima takes one on each side of the axle.

It is a direct-fit front right outer tie rod for the 2019-2025 Nissan Altima.

Specifications

• Position: front right outer
• Quantity per vehicle: 1
• Corrosion protection: anti-corrosion protection applied to each part

Interchange:
D8520-6CA0A · 544-356
1018809 · ES801645 · MS30668 · X36TE0803

Product information is for general reference and may contain errors. See our Disclaimer.