Keep your steering precise and responsive with the Delphi tie rod end (TA5015), an inner steering tie rod end that drops in as a direct-fit replacement for the 2007-2013 Acura MDX and 2010-2013 Acura ZDX. It connects the steering rack to the outer tie rod, transmitting your steering input to the wheel while allowing the joint to articulate with suspension travel. See the Buyer's Guide tab for the full engine-level fitment.
OE-level validation: Delphi applies its OE steering expertise to the aftermarket, testing parts below -40°C and above 120°C plus 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Micron-tolerance ball stud: the ball stud is machined to micron tolerances for durable, smooth joint operation.
Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure.
Corrosion protection: anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
Accessories included: ships with the accessories Delphi provides for a complete job.
Signs this inner tie rod end may need replacing include loose or wandering steering, a knocking feel when turning, and uneven tire wear. If a worn inner tie rod end is the cause, this replaces it. Replacing both sides as a pair is good practice for balanced steering.
It is a direct-fit inner steering tie rod end for the 2007-2013 Acura MDX and 2010-2013 Acura ZDX. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this an inner or outer tie rod end?
This is an inner steering tie rod end, which connects the steering rack to the outer tie rod and transfers your steering input toward the wheel.
What are the signs I need to replace this tie rod end?
Loose or wandering steering, a knocking feel when turning, and uneven tire wear can all point to a worn tie rod end. Diagnose the cause before replacing.
Does it come with the parts needed to install it?
Delphi includes the accessories it provides for a complete job. Consult the vehicle service information for correct torque and any additional fasteners.
Should I replace both tie rod ends at once?
Replacing the tie rod ends on both sides together as a matched pair is good practice for even, balanced steering, though it is not strictly required.
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
