Delphi Steering Tie Rod End P/N:TA5198

Be the first to review this product
$27.99
MPN: TA5198
UPC: 689604288115
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Delphi Steering Tie Rod End P/N:TA5198
Delphi Steering Tie Rod End P/N:TA5198
$27.99

Tighten up loose, wandering steering with the Delphi tie rod — the inner Steering Tie Rod End (P/N TA5198), a direct-fit replacement for the 2003-2004 Nissan Murano. Delphi applies its OE steering expertise to this aftermarket inner joint, so if a worn inner tie rod end is behind your play in the wheel, uneven tire wear, or clunk while turning, this replaces it.

  • OE-level testing: parts withstand temperatures below -40°C and over 120°C and are exposed to 720 hours of salt spray, with extensive dimensional and material analysis for close compatibility with the original.
  • Micron-tolerance ball stud: the ball stud is machined to micron tolerances for durability and smooth joint operation.
  • Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure.
  • Anti-corrosion protection: applied to each part for corrosion prevention and enhanced aesthetics.

Delphi includes the necessary accessories for a complete job. This is a steering tie rod end (track rod end), so consult the vehicle service information for correct torque and any alignment required after installation.

Interchange: 101-6039 · 612.42032 · 48521-CA025 · 535-311
1016039 · 61242032 · 48521CA025 · 535311 · TI69000 · TI69000PR · EV80625 · MEV80625 · JAR1174

This part cross-references / interchanges with the following part numbers:

101-6039, 612.42032, 48521-CA025, 535-311, TI69000, TI69000PR, EV80625, MEV80625, JAR1174

Frequently Asked Questions

Does this Delphi tie rod end fit my Nissan Murano?

Yes, P/N TA5198 is a direct-fit replacement for the 2003-2004 Nissan Murano. See the Buyer's Guide tab to confirm the exact application for your vehicle.

Is this an inner or outer tie rod end?

This is the inner Steering Tie Rod End (track rod end). It connects to the steering rack and transfers steering motion toward the outer joint and wheel.

What are the signs a tie rod end may need replacing?

Common signs include play or looseness in the steering, uneven or feathered tire wear, and a clunk or knock when turning. Have the cause diagnosed, as these symptoms can have other sources.

Does it come with the hardware needed to install it?

Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for correct torque values and any fasteners that may be single-use.

Is a wheel alignment needed after installation?

Replacing a tie rod end affects toe, so an alignment is typically recommended afterward. Follow the vehicle service procedure for the correct steps.