Delphi Steering Tie Rod End P/N:TA1289
Tighten up loose, wandering steering with the Delphi tie rod end (P/N TA5293), the OUTER tie rod end that links the steering system to the knuckle and transmits steering input to the wheel. It installs as a direct-fit replacement for the 1995-2005 Chevrolet Cavalier and 1995-2005 Pontiac Sunfire — see the Buyer's Guide tab for engine-level detail.
Delphi backs its aftermarket steering portfolio with OE expertise, testing parts to the extreme for OE performance: components withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, while extensive dimensional and material analysis targets close OE-to-aftermarket compatibility.
Signs this outer tie rod end may need replacing include loose or wandering steering, a knocking or clunking felt through the wheel when turning, and uneven or feathered front tire wear. If a worn outer tie rod end is the cause, this replaces it.
Interchange: 612.62085
61262085 · 26033527 · 26057931 · T3374 · T3374XL · ES3374RL · GES3374RL · MES3374RL · JTE1337
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi tie rod end TA5293 fit?
It is a direct-fit outer tie rod end for the 1995-2005 Chevrolet Cavalier and 1995-2005 Pontiac Sunfire. Check the Buyer's Guide tab to confirm the match for your specific vehicle.
Is this an inner or outer tie rod end?
This is the OUTER tie rod end, which connects the steering linkage to the steering knuckle and transmits steering motion to the front wheel.
What are the signs I may need this Delphi tie rod end?
Loose or wandering steering, a knocking or clunking felt through the wheel when turning, and uneven front tire wear can indicate a worn outer tie rod end. Diagnose the cause before replacing.
Does this Delphi track rod end include the hardware needed to install it?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for torque specs and the correct installation procedure.
How is the Delphi tie rod built for durability?
The ball stud is machined to micron tolerances for durability and smooth joint operation, the tie rod is fatigue tested, and anti-corrosion protection is applied to each part.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.