Tighten up loose steering with the Delphi tie rod end (MPN TA5628), an inner Steering Tie Rod End that drops in as a direct-fit replacement for the 2013-2018 Acura RDX. The inner tie rod end links the steering rack to the outer tie rod, transferring your steering input to the wheel while allowing the joint to pivot and articulate with suspension travel.
Delphi OE safety technology: tested to the extreme for OE performance — the part withstands temperatures below -40 °C and over 120 °C and is exposed to 720 hours of salt spray, with extensive dimensional and material analysis for the best OE-to-aftermarket compatibility.
Complete job: Delphi includes the necessary accessories for the installation.
Micron-machined ball stud: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure, with anti-corrosion protection applied to each part for corrosion prevention and enhanced aesthetics.
Signs an inner tie rod end may need replacing include loose or wandering steering, play in the joint, uneven tire wear, or a clunk when turning — diagnose the cause before replacing. Tie rod ends install as pairs; consider replacing both sides for balanced steering.
Interchange: 101-7805 · 612.40127 · 53010-TX4-A01
1017805 · 61240127 · 53010TX4A01 · TI50120 · TI50120PR · EV801147 · GS60730 · MS60730
This part cross-references / interchanges with the following part numbers:
101-7805, 612.40127, TI50120, TI50120PR, 53010-TX4-A01, EV801147, GS60730, MS60730
