Keep your steering tight and your suspension pivoting smoothly with the Delphi ball joint TC1702, a front lower suspension ball joint that drops in as a direct-fit replacement for the 1993-2002 Mercury Villager and 1993-2002 Nissan Quest. It connects the lower control arm to the steering knuckle, letting the suspension travel and the wheel steer while carrying load through the joint. See the Buyer's Guide tab for the full engine-level list.
Built on Delphi OE expertise: tested to the extreme for OE performance — withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
High-quality forging: forged for increased strength and smooth operation.
Chloroprene rubber boot: improves durability and helps prevent premature failure.
Micron-tolerance machining & anti-corrosion protection: machined to micron tolerances for durability and smooth joint operation, with anti-corrosion protection applied for corrosion prevention and enhanced aesthetics.
If a worn ball joint is behind clunking over bumps, loose or wandering steering, or uneven tire wear, this Nissan Quest ball joint replaces the original. Ball joints wear as a pair — inspect the opposite side and replace together where the service procedure recommends.
It's a front lower suspension ball joint that connects the lower control arm to the steering knuckle, letting the suspension travel and the wheel steer while carrying load through the joint.
Does it fit my Nissan Quest?
It's a direct-fit replacement for the 1993-2002 Nissan Quest and 1993-2002 Mercury Villager. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
What are signs this ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
What is the boot made of?
It uses a chloroprene rubber boot, which improves durability and helps prevent premature failure of the joint.
Should I replace both sides at once?
Ball joints wear as a pair, so it's good practice to inspect the opposite side and replace both together where the service procedure recommends for balanced handling.
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
