Keep your steering tight and your suspension located with the Delphi Suspension Ball Joint TC3677, a direct-fit replacement for the 2011 Jeep Grand Cherokee and 2011 Dodge Durango. The catalog lists this joint for the FRONT LOWER and REAR LOWER positions; see the "Vehicles it fits" section for engine-level detail on your vehicle.
Delphi builds on its OE engineering, and this joint carries the same testing discipline over into the aftermarket portfolio:
- Forged construction: made with high-quality forgings for added strength and smooth operation.
- Chloroprene rubber boot: improves durability and helps guard against premature failure.
- Micron-tolerance machining: machined to micron tolerances for durability and smooth joint operation.
- Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Delphi validates to extremes — withstanding temperatures below -40°C and above 120°C, plus 720 hours of salt spray — with extensive dimensional and material analysis for close OE-to-aftermarket compatibility. If a worn ball joint is behind your symptoms, this replaces it. Replacing the joints on both sides of an axle together is recommended for even, balanced handling.
Interchange: 6829 8603AA · 68298 603AB
68069648AB · 68282728AD · KBJ4297 · BJ82435 · BJ82435XL · K500372 · MS25518 · TXMS25518 · 68298603AA · 68298603AB
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
68069648AB, 68282728AD, 6829 8603AA, 68298 603AB, KBJ4297, BJ82435, BJ82435XL, K500372, MS25518, TXMS25518
Frequently Asked Questions
Does this Delphi ball joint fit my 2011 Jeep Grand Cherokee?
It's a direct-fit replacement for the 2011 Jeep Grand Cherokee. Check the "Vehicles it fits" section to confirm your specific vehicle and engine.
Does this ball joint fit the 2011 Dodge Durango?
Yes, it is a direct-fit replacement for the 2011 Dodge Durango. See the "Vehicles it fits" section for the full application detail.
What position is this ball joint for?
The catalog lists it for the FRONT LOWER and REAR LOWER positions. Confirm the correct position for your vehicle before ordering.
What are signs this ball joint may need replacing?
Clunking or knocking over the suspension, uneven tire wear, or looseness in the steering can be signs of a worn ball joint. Diagnose the cause before replacing.
How is this Delphi ball joint built?
It uses high-quality forgings for strength, micron-tolerance machining for smooth operation, a chloroprene rubber boot, and anti-corrosion protection applied to each part.
