Keep the front suspension tight and the steering precise with the Delphi Suspension Ball Joint TC6949, a front lower ball joint that connects the control arm to the steering knuckle so the suspension can travel and the wheel can steer. It's a direct-fit replacement for the 2015-2023 Ford Transit-150, 2015-2023 Ford Transit-250, 2015-2023 Ford Transit-350, and 2015-2023 Ford Transit-350 HD.
Delphi builds on its OE expertise for the aftermarket steering portfolio, testing to the extreme for OE performance — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
- Forged construction: high-quality forgings for increased strength and smooth operation.
- Chloroprene rubber boot: improves durability and helps prevent premature failure.
- Micron-tolerance machining: supports durability and smooth joint operation.
- Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Clunking over bumps, wandering or loose steering, and uneven tire wear are signs a worn ball joint may need replacing. Diagnose the cause before ordering, and if a failed front lower ball joint is the issue, this replaces it.
Interchange: BK3Z 3050-A
BK3Z3050A · RK100398
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this ball joint do?
It's a front lower ball joint that connects the control arm to the steering knuckle, allowing the suspension to travel and the wheel to steer while supporting and locating the front suspension.
Will it fit my vehicle?
It's a direct-fit replacement for the 2015-2023 Ford Transit-150, Transit-250, Transit-350, and Transit-350 HD. Confirm your specific application in the Buyer's Guide tab.
What are signs my ball joint needs replacing?
Clunking over bumps, wandering or loose steering, and uneven front tire wear can all point to a worn ball joint. Have the cause diagnosed before replacing.
How is this Delphi ball joint built?
It uses high-quality forgings for strength and smooth operation, a chloroprene rubber boot for durability, micron-tolerance machining, and anti-corrosion protection on each part.
Has this part been tested for durability?
Delphi tests to the extreme for OE performance: parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, backed by dimensional and material analysis.
Write a Review