Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2163
$270.99
(You save)
Keep your Land Rover's wheel located and the ride under control with the Delphi control arm assembly TC2163, a direct-fit replacement for the 2005-2009 Land Rover LR3 and 2006-2014 Land Rover Range Rover Sport. This control arm and ball joint assembly is cataloged for the front right lower and rear right lower position; see the Buyer's Guide tab for the engine applications.
Tested for OE performance: withstands temperatures below -40°C and over 120°C plus 720 hours of salt spray, with dimensional and material analysis for compatibility between the OE and aftermarket part.
100% inspected: each control arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: ball studs machined to micron tolerances for durability and smooth joint operation.
Robot-welded and protected: robot welding for consistent quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
The arm connects the steering knuckle to the chassis and lets the suspension pivot as the wheel travels. A worn control arm bushing or ball joint can show up as clunking over bumps, uneven tire wear, vibration, or loose, wandering steering. If that is the cause, this Land Rover LR3 control arm replaces the failed mounting and pivot points. It's a common fit for Range Rover Sport front suspension arms as well.
Frequently Asked Questions
What vehicles does the Delphi TC2163 control arm fit?
It's a direct-fit replacement for the 2005-2009 Land Rover LR3 and 2006-2014 Land Rover Range Rover Sport. Check the Buyer's Guide tab to confirm the engine and application for your vehicle.
Where does this LR3 control arm mount?
The catalog lists it for the front right lower and rear right lower position. Confirm which position applies to your vehicle in the Buyer's Guide before ordering.
What are the signs this control arm and ball joint assembly may need replacing?
Clunking over bumps, uneven tire wear, vibration, or loose, wandering steering can signal a worn control arm bushing or ball joint. Diagnose the cause before replacing.
Is the ball joint included with this assembly?
Yes. The ball joint comes as part of the complete assembly, with ball studs machined to micron tolerances for durability and smooth joint operation.
What should I know before reading Delphi control arm reviews?
Delphi applies its OE expertise to the aftermarket. These parts undergo 100% crack and ultrasonic flaw detection plus salt-spray testing to help match OE specifications.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2163
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Keep steering tight and suspension geometry accurate with the Delphi control arm and ball joint assembly (TC6341), a front left lower unit that installs as a direct-fit replacement for the 2006-2011...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Firm up steering and restore control on your truck with the Delphi Suspension Control Arm and Ball Joint Assembly (TC6246), a direct-fit Ram 1500 lower control arm for the 2002-2005 Dodge Ram 1500...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
