Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8295
Keep your Nissan's front suspension located and tracking true with the Delphi control arm — the front left lower control arm and ball joint assembly TC2873. This unit positions the wheel, pivots through suspension travel, and carries an integrated ball joint. It installs as a direct-fit replacement on the 2009-2014 Nissan Cube and 2007-2012 Nissan Versa; see the Buyer's Guide tab for the full engine list.
Shopping for a Nissan Versa control arm — including a 2012 Nissan Versa control arm — this is your driver's-side lower piece. Clunking, wandering steering, or uneven front tire wear can be signs the control arm or ball joint may be worn; have the cause diagnosed before replacing.
Interchange: 101-6030 · 102-6030 · 623.4207 · 54501-1FU0A · 54501-1JY0A · 54501-EL000 · 54501-EL00D · 54501-ET000 · 54501-EW000 · 521-083
1016030 · 1026030 · 6234207 · 545011FU0A · 545011JY0A · 54501EL000 · 54501EL00D · 54501ET000 · 54501EW000 · 521083 · CB69203 · CB69203PR · CK620567 · K620567 · RK620567 · CMS30145 · GS30145 · MS30145 · JTC1857
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi TC2873 fit?
It's the front left lower control arm and ball joint assembly for the 2009-2014 Nissan Cube and 2007-2012 Nissan Versa. Check the Buyer's Guide tab to confirm the engine for your vehicle.
What position is this control arm?
It's the front left (driver's side) lower control arm with an integrated ball joint. As best practice, consider replacing the matching side too for balanced suspension wear.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into the assembly, so you replace the arm and joint together rather than pressing a separate ball joint into an old arm.
What are signs this control arm may need replacing?
Clunking over the front suspension, wandering steering, uneven front tire wear, or a loose ball joint can point to a worn control arm. Diagnose the cause before replacing.
What testing does Delphi apply to this part?
Delphi runs 100% crack detection and ultrasonic flaw detection so materials match OE specifications, machines the ball studs to micron tolerances, and uses robot welding for consistent quality.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.