Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3016
$206.99
(You save)
Bring precise steering and a solid front end back to your ride with the Delphi control arm and ball joint assembly, MPN TC3016. This front left lower unit is a direct-fit replacement for the 2010-2015 Hyundai Tucson and the 2011-2016 Kia Sportage, locating the front wheel while its integrated ball joint allows the steering and suspension to move together. Delphi applies its OE engineering experience to this aftermarket steering part, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket component.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray for demanding conditions.
OE-matched materials: 100% crack detection and ultrasonic flaw detection help confirm the materials match OE specifications.
Precision ball studs: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robotic welding for consistent quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
If a worn control arm or ball joint is behind clunking over the front suspension, uneven tire wear, or loose steering, this assembly replaces it. Delphi control arm reviews often note the OE-level fit — check the Buyer's Guide tab to confirm your engine.
What vehicles does the Delphi TC3016 control arm and ball joint assembly fit?
It is a direct-fit replacement for the 2010-2015 Hyundai Tucson and the 2011-2016 Kia Sportage. Check the Buyer's Guide tab to confirm the exact engine for your vehicle.
Is this a front or rear part, and which side?
This is the front left lower control arm and ball joint assembly for the listed applications.
Is the ball joint included with this Kia Sportage control arm?
Yes. The ball joint is integrated into the assembly, so you replace the control arm and its ball joint together as one unit.
How was this Hyundai Tucson lower arm tested?
Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and uses 100% crack and ultrasonic flaw detection to help match OE specifications.
What are signs my control arm or ball joint may need replacing?
Clunking over the front suspension, uneven tire wear, or loose, wandering steering can be signs. Diagnose the cause first; if the control arm or ball joint is at fault, this replaces it.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3016
Locate the front wheel and manage suspension travel with the DELPHI control arm TC6664, a front right lower control arm and ball joint assembly that drops in as a direct-fit replacement for the...
Keep the rear wheels located and the suspension geometry tight with the Delphi control arm, MPN TC6869, a direct-fit replacement for the 2006-2010 Toyota RAV4. This rear control arm and ball joint...
Keep your front end tight and steering precise with the Delphi control arm and ball joint assembly (P/N TC6164), a direct-fit front upper unit for the 2003-2005 Dodge Ram 2500 and 2003-2005 Dodge Ram...
Steer with confidence and quiet the knocks up front with the Delphi control arm and Ball Joint Assembly TC2204 — a front left lower unit that locates the wheel, absorbs road inputs, and pivots on an...
Tighten up a loose, clunking front end with the Delphi control arm TC5214, a front right lower suspension control arm and ball joint assembly that drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
