Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3017
$214.99
(You save)
Steer confidently with the Delphi control arm TC3017, the front right lower unit that locates the wheel and lets it move through its travel while the integrated ball joint allows the knuckle to pivot for steering. It drops in as a direct-fit replacement for the 2010-2012 Hyundai Tucson and 2010-2012 Kia Sportage (see the Buyer's Guide tab for the full engine-level fitment).
OE-derived design: Delphi applies its OE steering expertise to the aftermarket portfolio, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
Quality-checked build: 100% crack detection and ultrasonic flaw detection confirm materials match OE specifications; ball studs are machined to micron tolerances and the arm uses robot welding for consistent quality.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Worn control arm bushings or a loose ball joint can cause clunks, uneven tire wear, or wandering steering; if this front right lower arm is the cause, replacing it addresses those signs. This is an option for shoppers searching for a 2010-2012 Hyundai Tucson lower arm.
It is a direct-fit front right lower control arm for the 2010-2012 Hyundai Tucson and 2010-2012 Kia Sportage. Check the Buyer's Guide tab to confirm your exact engine and configuration.
What does this control arm and ball joint assembly do?
It locates the front wheel and lets it move through suspension travel, while the integrated ball joint allows the steering knuckle to pivot for steering and ride control.
Which position is this Delphi part?
This is the front right (passenger side) lower control arm assembly. It fits that specific corner on the listed applications.
What are signs this part may need replacing?
Clunking over bumps or during turns, uneven tire wear, or wandering steering can point to worn bushings or a loose ball joint. Diagnose the cause before replacing.
Is this 2010-2012 Kia Sportage control arm the same part that fits the 2010-2012 Hyundai Tucson?
Yes. The same Delphi TC3017 front right lower arm is listed for both the 2010-2012 Hyundai Tucson and the 2010-2012 Kia Sportage.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3017
Help locate the wheel and address worn-joint noise with the Delphi control arm and ball joint assembly, MPN TC8063 — a rear left upper unit that installs as a direct-fit replacement for the listed...
Steer with confidence and quiet the front suspension with the Delphi Control Arm with Ball Joint TC5025, a front left upper control arm and ball joint assembly. This Ford Fusion control arm installs...
Delphi TC4692 control arm with ball joint for the 2022-2025 BMW M8 and other vehicles replaces the front right upper arm and its ball joint as one assembly. This control arm and ball joint assembly...
Help keep steering precise and wheel control steady with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
