Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3150
$119.99
(You save)
Keep the front suspension located and articulating with the Delphi control arm TC3150, a front right lower rearward control arm and ball joint assembly built with Delphi's OE safety technology. It installs as a direct-fit replacement for the 2017-2022 Land Rover Discovery, the 2014-2015 and 2018-2020 Land Rover Range Rover, and the 2014-2017 Land Rover Range Rover Sport. See the Buyer's Guide tab for the full engine coverage.
The arm positions the front right lower rearward suspension while its integrated ball joint lets the wheel steer and travel through its range of motion.
Tested to the extreme: withstands temperatures below -40°C and over 120°C plus 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection help ensure materials match OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robot welding for consistent quality, plus anti-corrosion protection applied to each part.
Signs this assembly may need replacing include clunking over the front suspension on acceleration or bumps, loose or wandering steering, or uneven front tire wear — diagnose the cause before replacing. Replace worn suspension parts as your vehicle service information directs.
Is this the right Range Rover control arm for my vehicle?
Yes, it's a direct-fit for the 2014-2015 and 2018-2020 Land Rover Range Rover, plus the 2017-2022 Discovery and 2014-2017 Range Rover Sport. Check the Buyer's Guide tab for your engine.
What position on the vehicle is TC3150?
It's the front right lower rearward control arm and ball joint assembly.
Will it fit a Range Rover Sport?
Yes, it's a direct-fit Range Rover Sport control arm for the 2014-2017 Land Rover Range Rover Sport.
How do I know if my control arm needs replacing?
Signs may include clunking over bumps, loose or wandering steering, and uneven front tire wear. Have the cause diagnosed first, since these symptoms can have other sources.
Is the ball joint included with this Delphi control arm?
Yes, the ball joint is integrated into this assembly, so the arm and ball joint are replaced together as one unit.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3150
Help bring back a steady, connected feel to the front end by replacing a worn Honda Civic control arm with the Delphi TC1075, a front right upper control arm with ball joint that installs as a...
Keep your front suspension linked to the chassis with the Delphi control arm TC1043, a front left upper control arm and ball joint assembly whose built-in ball joint lets the wheel pivot for steering...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
