Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3292
$125.99
(You save)
Help restore precise wheel location and quiet suspension travel with the Delphi control arm and ball joint assembly, MPN TC3292. This front left lower unit drops in as a direct-fit replacement for the 2007-2011 Hyundai Santa Fe and 2011-2012 Kia Sorento — see the Buyer's Guide tab for the full engine-level fitment. The arm locates the wheel while the integrated ball joint allows steering and suspension movement, so a worn assembly can show up as clunking on acceleration or over uneven pavement, loose steering, or uneven tire wear.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close OE-to-aftermarket compatibility; parts are tested below -40°C and above 120°C and endure 720 hours of salt spray.
Verified materials: 100% crack detection and ultrasonic flaw detection confirm the material matches OE specifications.
Precision ball studs: ball studs are machined to micron tolerances for durability and smooth joint operation.
Built for consistency: robot-welded for repeatable quality, with anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
It is a direct-fit replacement for the 2007-2011 Hyundai Santa Fe and 2011-2012 Kia Sorento. Check the Buyer's Guide tab to confirm the exact engine and configuration for your vehicle.
Is this a front left lower control arm?
Yes. TC3292 is the front left (driver-side) lower control arm with an integrated ball joint for the listed applications.
Will this work as a 2012 Kia Sorento lower control arm replacement?
Yes, the 2012 Kia Sorento is within the covered 2011-2012 range. Verify your specific configuration in the Buyer's Guide tab before ordering.
What are the signs I may need this control arm?
Common signs include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
Does the assembly include the ball joint?
Yes. The ball joint is integrated into this assembly, so replacing the arm replaces the joint as one unit.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3292
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Help keep steering tight and suspension geometry accurate with the Delphi control arm and ball joint assembly (TC6341), a front left lower unit that installs as a direct-fit replacement for the...
Firm up steering and restore control on your truck with the Delphi Suspension Control Arm and Ball Joint Assembly (TC6246), a direct-fit Ram 1500 lower control arm for the 2002-2005 Dodge Ram 1500...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
