Delphi TC3784 front right lower control arm with ball joint for the 2003-2006 Mitsubishi Outlander links the steering knuckle to the vehicle. The arm carries a ball joint, which lets the wheel pivot for steering as the suspension moves.
- 100% crack detection and ultrasonic flaw detection on each control arm
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot-welded control arm for consistent performance and quality
- Anti-corrosion protection applied to each part
- Tested at temperatures below -40 °C and over 120 °C, and exposed to 720 hours of salt spray
Quick facts
- Part: Delphi TC3784 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2003-2006 Mitsubishi Outlander
- Position: Front right lower
- Condition: New
A clunk over bumps, loose steering or uneven front tire wear can mean a worn lower arm or ball joint. Before you replace this one, rule out a worn strut, tie rod end or sway bar link, since those can make similar noises.
Fits
It fits the 2003-2006 Mitsubishi Outlander, which takes one on the front right side. This listing is one piece; the front left is a separate part, and both sides are normally replaced together.
Specifications
Fit and size
- Position: front right lower
- Quantity per vehicle for this side: 1
Build and materials
- Construction: robot-welded control arm with ball joint
- Finish: anti-corrosion protection
- Condition: new
Interchange: 102-6575 · 102-6576 · 520-376
KSC5595 · CB67104 · CB67104PR · CK620546 · RK620546 · CMS80131 · GS80131 · 4013A132 · MN101742 · MR961392 · JTC7614
This part cross-references / interchanges with the following part numbers:
102-6575, 102-6576, 520-376, KSC5595, CB67104, CB67104PR, CK620546, RK620546, CMS80131, GS80131, 4013A132, MN101742, MR961392, JTC7614
Frequently Asked Questions
Does the Delphi TC3784 fit the 2003-2006 Mitsubishi Outlander?
Yes. Delphi TC3784 is a front right lower control arm with ball joint for the 2003-2006 Mitsubishi Outlander. The left side takes its own separate part.
How is this front right lower control arm tested for heat, cold and rust?
The arm withstands temperatures below -40 °C and over 120 °C and is exposed to 720 hours of salt spray. Anti-corrosion protection is applied to each part.
How precisely are the ball studs on the Delphi TC3784 made?
The ball studs on Delphi TC3784 are machined to micron tolerances. This is meant to give durability and smooth joint operation.
Does this control arm and ball joint assembly come with the ball joint included?
Yes. The ball joint is part of this front right lower arm, so the arm and joint come as one piece.
What are the signs of a worn lower control arm or ball joint?
A clunk over bumps, loose steering or uneven front tire wear can point to a worn arm or ball joint. A shop can inspect the joint for play.
