Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5185
$143.99
(You save)
When your Honda Odyssey control arm wears out, the Delphi Suspension Control Arm and Ball Joint Assembly TC5185 drops in as a direct-fit replacement for the 2005-2010 Honda Odyssey. This front left lower control arm and ball joint assembly combines the arm and its integrated ball joint into one unit, locating the suspension and supporting the steering knuckle so the wheel stays aligned as it moves through its travel.
OE-derived validation: Delphi tests below -40°C and above 120°C and exposes each part to 720 hours of salt spray, with dimensional and material analysis targeting close OE-to-aftermarket compatibility.
Verified materials: every arm gets 100% crack detection and ultrasonic flaw detection so the material matches OE specifications.
Precision joint: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Corrosion-guarded build: anti-corrosion protection is applied for corrosion prevention and appearance, and Delphi control arms use robot welding for consistent quality.
Signs the original may need replacing include clunking over bumps, loose or wandering steering, and uneven tire wear; if a worn control arm or ball joint is the cause, TC5185 replaces it. It covers the front left lower corner, so shopping a 2005 Honda Odyssey control arm or a 2008 Honda Odyssey lower control arm lands on this part. Sold individually; the opposite side is a separate part.
It's a front left lower suspension control arm with an integrated ball joint, sold as one assembly. It locates the suspension and supports the steering knuckle to keep the wheel aligned through its travel.
Does this fit my 2006 Honda Odyssey control arm application?
Yes. TC5185 is a direct-fit replacement for the 2005-2010 Honda Odyssey, front left lower position. See the Buyer's Guide tab to confirm your exact vehicle.
What are the signs my control arm or ball joint is worn?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can come from other suspension parts too.
Do I need to replace both sides?
This part is sold individually and covers the front left lower corner; the opposite side is a separate part. Replacing suspension parts in matched pairs is good practice for balanced handling.
What testing does the Delphi control arm go through?
Delphi tests below -40°C and above 120°C plus 720 hours of salt spray, and uses 100% crack and ultrasonic flaw detection so materials match OE specifications.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5185
Help restore steady, quiet steering and control with this Delphi control arm and integrated ball joint (P/N: TC5783), a front right lower unit that carries the OE expertise Delphi builds into...
Locate the front wheel and pivot the steering knuckle with the Delphi control arm TC6296, a front right lower control arm and ball joint assembly that positions the wheel and rides on an integrated,...
Help maintain proper front-end geometry with the Delphi control arm and ball joint assembly, part number TC1708. This front right upper unit is a direct-fit replacement for many vehicles, among them...
Help keep the wheel securely located with the Delphi control arm and ball joint assembly (TC805) — a Delphi control arm cataloged for the front right upper and lower position. It's a direct-fit...
Help address sloppy steering and keep proper wheel location with the Delphi control arm, part number TC2065 — a direct-fit front left lower rearward assembly for the 2000-2006 BMW X5. This control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
