Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6340
$210.99
(You save)
Keep the front wheel properly located and steering movement smooth with the Delphi control arm TC6340, a front left lower control arm and ball joint assembly that installs as a direct-fit replacement for the 2006-2011 Buick Lucerne and 2006-2011 Cadillac DTS.
Delphi applies its OE steering expertise to this aftermarket assembly and tests it hard: parts withstand temperatures below -40°C and above 120°C and endure 720 hours of salt spray, while extensive dimensional and material analysis targets close compatibility between the OE and aftermarket part.
100% flaw inspected: every arm goes through crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: the ball stud is machined to micron tolerances for durability and smooth joint operation.
Robot-welded: robotic welding delivers consistent build quality from part to part.
Anti-corrosion protection: a corrosion-resistant treatment is applied to each part for corrosion prevention and improved appearance.
If a worn control arm bushing or ball joint is behind clunking over bumps, loose steering, or uneven front tire wear, this assembly replaces the original. Sold as a single front left-side unit.
What vehicles does the Delphi control arm TC6340 fit?
It's a direct-fit replacement for the 2006-2011 Buick Lucerne and 2006-2011 Cadillac DTS. Check the Buyer's Guide tab to confirm your exact vehicle.
Which corner of the vehicle does this fit?
This is the front left (driver-side) lower control arm with its integral ball joint.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into the assembly, so you replace the arm and the joint together as one unit.
What are signs my Cadillac Dts control arm needs replacing?
Clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear can point to a worn control arm bushing or ball joint. Diagnose the cause before replacing.
What quality checks back up Delphi control arm reviews?
Delphi puts every control arm through 100% crack and ultrasonic flaw detection, machines the ball studs to micron tolerances, and applies anti-corrosion protection to each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6340
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
Locate and support your front wheel with the Delphi control arm TC6248, a FRONT RIGHT UPPER control arm and ball joint assembly built as a direct-fit replacement for the 2005-2006 Ford Expedition and...
Keep the rear suspension properly located with the Delphi TC7868, a rear upper Honda Accord control arm built as a direct-fit replacement for the 1998-2002 Honda Accord, 2001-2003 Acura CL and...
Keep your Audi's front suspension located and steering-true with the Delphi control arm and ball joint assembly (TC801). This is the front left upper rearward arm, a direct-fit replacement that pairs...
Restore precise steering and a solid front end with the Delphi control arm TC802, a direct-fit replacement control arm and ball joint assembly for the front right upper rearward position on a wide...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
