Control Arm with Ball Joint for 2021-2022 Audi RS6 Avant & More - Delphi TC7776

$65.99
WARNING:California Proposition 65▾

Vehicles this part fits

    Part number: TC7776
    UPC: 689604368138
    Condition: New
    Weight: 1.20 LBS
    Item Package Quantity: 1
    $65.99
    Adding to cart… The item has been added

    Have questions?

    Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7776
    Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7776
    $65.99
    $65.99

    Locate and control the front suspension with the Delphi control arm — the TC7776 control arm and ball joint assembly. It's cataloged for the front left upper rearward position and installs as a direct-fit replacement for many vehicles, among them the 2019-2022 Audi A6 Quattro, 2018-2022 Audi Q5 and 2017-2022 Audi Q7. See the "Vehicles it fits" section for the full list of Audi and Porsche fitments.

    Delphi applies its OE safety technology and expertise to its aftermarket steering portfolio, backing each part with extensive dimensional and material analysis for close OE compatibility:

    • Tested to the extreme: withstands temperatures below -40°C and above 120°C and endures 720 hours of salt spray.
    • 100% inspected: every arm goes through crack detection and ultrasonic flaw detection so materials match OE specifications.
    • Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
    • Robot-welded and protected: robot welding for consistent quality, with anti-corrosion protection applied to each part for corrosion prevention and improved appearance.

    Country of origin: Turkey. A worn ball joint or control arm can show up as clunking over bumps, steering wander, or uneven tire wear; if the arm or its integrated ball joint is the cause, this assembly replaces it. Have a wheel alignment performed after installation.

    Interchange: 4M0 407 509 B
    4M0407509B · KSC4281

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    4M0 407 509 B, KSC4281

    Frequently Asked Questions

    What does the Delphi TC7776 do?

    It's a front left upper rearward control arm with a ball joint that locates the wheel and allows suspension and steering movement, combining the arm and its ball joint in one serviceable unit.

    Which vehicles does this control arm fit?

    It's a direct-fit replacement for many vehicles, including the 2019-2022 Audi A6 Quattro, 2018-2022 Audi Q5 and 2017-2022 Audi Q7. Check the "Vehicles it fits" section for the full list.

    What position does it install in?

    The catalog lists this assembly for the front left upper rearward position on the covered vehicles.

    Is this Delphi part a quality replacement?

    It draws on Delphi's OE safety technology, with 100% crack detection, ultrasonic flaw detection, and ball studs machined to micron tolerances.

    Do I need an alignment after installing it?

    A wheel alignment is recommended after replacing a control arm. Diagnose the cause of any clunk or steering issue first, since these symptoms can come from other suspension parts too.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review