Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC9384
Delphi TC7779 control arm with ball joint for the 2017-2022 Audi Q7 and other vehicles links the steering knuckle to the body. This Delphi control arm and ball joint assembly is the front left, upper forward one.
A clunk over bumps, a loose or wandering feel in the steering or uneven tire wear can mean the arm or its ball joint is worn. These signs alone do not prove this arm is at fault, since a worn sway bar link can also clunk over bumps.
The 2018-2022 Audi Q5 and the 2018-2022 Audi SQ5 take it as well, along with many other Audi and Porsche models. If your car isn't named here, look up its year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with ball joint. The vehicle takes one of this left-side part, and this listing is sold individually, so the opposite side is a separate order and the two are normally replaced together.
Interchange: 4M0 407 505 B
1028208 · KSC4283 · RK623679 · CMS701154
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Delphi TC7779 an Audi Q5 control arm for model years 2018-2022?
Yes. Delphi TC7779 fits the 2018-2022 Audi Q5 and the 2017-2022 Audi Q7. It is the front left upper forward arm, and the vehicle takes one.
Is the Delphi TC7779 a left or right control arm?
This control arm is the front left upper forward one, and the vehicle takes one. The right side is a separate part.
How are the ball studs on this Delphi control arm made?
The ball studs on the Delphi TC7779 are machined to micron tolerances, which is meant to give durability and smooth joint operation. The arm itself is robot welded.
Is this Delphi control arm tested for cold, heat and salt?
Yes. Delphi's testing covers temperatures below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray, and anti-corrosion protection is applied to each arm.
Is it safe to drive on a worn control arm with a ball joint?
No. Wear in a control arm or its ball joint is a suspension problem, so have it inspected and replaced promptly.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.