Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8613
$77.99
(You save)
Steer with confidence and help restore proper suspension geometry with the DELPHI control arm and ball joint assembly (TC8613). This front right lower unit drops in as a direct-fit replacement for the 2014 Kia Forte, pairing the arm and its integrated ball joint into a single unit that locates the wheel and lets the steering knuckle pivot. Delphi applies its OE steering expertise to this aftermarket part, tested to the extreme for OE performance.
OE-validated durability: withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with extensive dimensional and material analysis for compatibility with the OE part.
Quality-controlled: undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision joint: ball studs machined to micron tolerances for durability and smooth joint operation.
Consistent build: robot welding for consistent performance, plus anti-corrosion protection applied for corrosion prevention and enhanced aesthetics.
If a worn front right lower arm or ball joint is the cause of clunking, uneven tire wear, or wandering steering on your Kia Forte, this assembly replaces it.
What vehicle does the DELPHI TC8613 control arm fit?
It is a direct-fit replacement for the 2014 Kia Forte. See the Buyer's Guide tab to confirm fitment for your exact vehicle.
Is this a front or rear part, and which side?
This is the front right lower control arm with an integrated ball joint.
Does this include the ball joint?
Yes. The control arm and its ball joint come as a single integrated assembly, so you replace both together.
What are signs I may need a Kia Forte control arm replacement?
Clunking over bumps, uneven or accelerated tire wear, and wandering or loose steering can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
How is the Delphi lower arm protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8613
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
