Delphi Suspension Control Arm Bushing Kit P/N:TD5432W

Be the first to review this product
$16.99
MPN: TD5432W
Item Package Code: EA
Part Has Core (Y/N): N
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Delphi Suspension Control Arm Bushing Kit P/N:TD5432W
Delphi Suspension Control Arm Bushing Kit P/N:TD5432W
$16.99

Quiet a clunking, wandering front end and firm up the connection between the upper control arm and the chassis with the Delphi Suspension Control Arm Bushing Kit TD5432W. It's a direct-fit replacement for the front upper position on the 1992-1994 Ford Crown Victoria and 1992-1994 Mercury Grand Marquis, restoring the locating and vibration-isolating cushion where the control arm pivots. See the Buyer's Guide tab for full engine-level fitment.

  • Built on OE expertise: Delphi applies the safety technology fitted to millions of vehicles worldwide to its aftermarket steering and suspension portfolio.
  • Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt spray for OE-level performance.
  • Designed to OE standards: extensive dimensional and material analysis targets close compatibility between the original and the replacement part.
  • Consistent, quieter operation: manufactured for consistent life and to reduce noise, helping restore the vehicle's smooth ride.

Worn or cracked control arm bushings can produce clunks on acceleration, deceleration or over bumps, imprecise steering and uneven tire wear. If failed bushings are the cause, this suspension control arm bushing kit replaces them. Inspect and service both sides as directed by the service procedure for balanced results.

Interchange: F2AC3068AA · K8664 · GK8664 · MK8276 · MK8616 · MK8664

This part cross-references / interchanges with the following part numbers:

F2AC3068AA, K8664, GK8664, MK8276, MK8616, MK8664

Frequently Asked Questions

What vehicles does the Delphi TD5432W bushing kit fit?

It's a direct-fit replacement for the 1992-1994 Ford Crown Victoria and 1992-1994 Mercury Grand Marquis. Check the Buyer's Guide tab to confirm the exact application for your vehicle.

Where on the suspension does this kit install?

It replaces the front upper control arm bushings, the cushioned pivots that locate the upper control arm to the chassis and isolate vibration.

What are signs my control arm bushings may need replacing?

Common signs include clunking on acceleration, deceleration or over bumps, vague or loose steering, and uneven tire wear. Diagnose the cause before replacing, since other parts can produce similar symptoms.

How is this suspension control arm bushing kit tested?

Delphi validates its parts below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for close compatibility to the original part.

Should I replace both sides at the same time?

Inspecting and servicing both sides together is good practice for balanced handling and even wear. Follow the vehicle service procedure for the correct steps and fasteners.