Delphi TD1004W front lower outer control arm bushing for the 1995-2012 Honda Accord and other vehicles cushions the lower control arm pivot. It lets the arm swing with the suspension while keeping it located.
- Made to reduce vibration and noise
- Manufactured for consistent service life
- Tested to withstand temperatures below -40 degrees C and over 120 degrees C
- Exposed to 720 hours of salt spray testing
- Dimensional and material analysis applied to the design
Quick facts
- Part: Delphi TD1004W control arm bushing
- Also called: suspension control arm bushing
- Fits: 1995-2012 Honda Accord and other vehicles
- Position: Front lower outer
- Material: Natural rubber
- Condition: New
Clunking over bumps, vague steering or uneven tire wear can mean this bushing is worn, but a tired ball joint or a loose tie rod end can be behind them too, so pin down the source before buying. Bushings are normally replaced as a pair, and this listing is one bushing; the 1995-2012 Honda Accord takes two.
Fits
Listed for a wide range of Honda and Acura models, it works as a 1995-2012 Honda Accord bushing and also fits the 1995-1998 Honda Odyssey and the 2012-2015 Honda Crosstour. It is designed to OE standards.
Specifications
Fit and size
- Position: front lower outer
- Quantity per vehicle: 2
- Pieces per listing: 1
Build and materials
- Material: natural rubber
- Installation: press fit
- Condition: new
Interchange: 101-6459 · 602.40001 · 51810-SDA-A01
BU01026 · BC59139 · BC59139PR · K200014 · MS60403 · MS60469 · JBU830
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
101-6459, 602.40001, 51810-SDA-A01, BU01026, BC59139, BC59139PR, K200014, MS60403, MS60469, JBU830
Frequently Asked Questions
Will Delphi TD1004W work as the bushing for the lower control arm on a 2007 Honda Accord in the 1995-2012 range?
Yes. Delphi TD1004W is listed for the 1995-2012 Honda Accord, and the Accord takes two. If your car is not named here, look it up in the Vehicles it fits section on this page.
Is Delphi TD1004W a Honda Odyssey control arm bushing for the 1995-1998 model years?
Yes. Delphi TD1004W is listed for the 1995-1998 Honda Odyssey, and the Odyssey takes two.
Is the Delphi TD1004W bushing a press-fit design?
Yes, this front lower outer bushing installs by press fit, and its material is natural rubber.
How do I tell whether a suspension control arm bushing is worn?
Cracked or torn rubber is one visible sign, and a shop can measure play in the joint.
Does Delphi TD1004W replace part number MS60403?
Yes. MS60403 is one of the other-brand numbers that Delphi TD1004W replaces.
