Keep the front suspension located and quiet with the Delphi Control Arm Bushing TD1677W, a direct-fit replacement for the front lower rearward position on the 2010 Buick Allure, 2010-2013 Buick LaCrosse, 2011-2013 Buick Regal, 2011-2013 Chevrolet Volt, 2013 Cadillac XTS, and 2013 Chevrolet Malibu. See the Buyer's Guide tab for engine-level fitment.
- Built to OE standards: Delphi applies its OE expertise to its aftermarket steering portfolio, with dimensional and material analysis aimed at OE-to-aftermarket compatibility.
- Tested to the extreme: validated below -40°C and above 120°C, plus 720 hours of salt spray.
- Manufactured for consistent life and to reduce noise.
- Manufactured to reduce vibration, and includes the necessary accessories for a complete job.
This suspension control arm bushing cushions the pivot where the control arm meets the frame, helping locate the arm while isolating road vibration and noise. If a worn or cracked bushing is behind clunking over bumps, imprecise steering, or uneven tire wear, replacing it addresses the failed part.
Interchange: 521-891 · 521-951 · 52-1952 · 905-526
521891 · 521951 · 521952 · 905526 · 13334021 · 13463244 · 22854825 · 22854826 · CB91223 · CB91223PR · CB91233PR · CB91234PR · K201258 · K201259 · MS504238
This part cross-references / interchanges with the following part numbers:
521-891, 521-951, 52-1952, 905-526, 13334021, 13463244, 22854825, 22854826, CB91223, CB91223PR, CB91233PR, CB91234PR, K201258, K201259, MS504238
