Rear Lower Control Arm Bushing for 2006-2011 Chevrolet HHR & More - Delphi TD4380W

$49.99
WARNING:California Proposition 65▾
Delphi Suspension Control Arm Bushing TD4380W
Delphi Suspension Control Arm Bushing TD4380W - view 2
Delphi Suspension Control Arm Bushing TD4380W - view 3
Delphi Suspension Control Arm Bushing TD4380W - view 4
Delphi Suspension Control Arm Bushing TD4380W - view 5
Delphi Suspension Control Arm Bushing TD4380W
Delphi Suspension Control Arm Bushing TD4380W - view 2
Delphi Suspension Control Arm Bushing TD4380W - view 3
Delphi Suspension Control Arm Bushing TD4380W - view 4
Delphi Suspension Control Arm Bushing TD4380W - view 5

Vehicles this part fits
    $49.99
    Adding to cart… The item has been added

    Have questions?

    Ask an Expert
    Part number: TD4380W
    UPC: 689604333921
    Delphi Suspension Control Arm Bushing P/N:TD4380W
    Delphi Suspension Control Arm Bushing P/N:TD4380W
    $49.99
    $49.99

    Cushion the rear lower control arm and dampen road vibration at the mounting point with the Delphi Suspension Control Arm Bushing TD4380W. It drops in as a direct-fit replacement on many vehicles, among them the 2006-2011 Chevrolet HHR, 2005-2010 Chevrolet Cobalt and 2007-2010 Pontiac G5 — see the "Vehicles it fits" section for the full list of applications.

    Delphi applies its OE expertise to its aftermarket steering portfolio, with dimensional and material analysis for close OE-to-aftermarket compatibility.

    • Designed to OE standards: Delphi bushings are designed to original-equipment standards.
    • Built for consistent life and quieter operation: manufactured to hold up over time and help reduce noise.
    • Reduced vibration: manufactured to help dampen road-induced vibration through the suspension.
    • Extreme-condition tested: validated below -40°C and above 120°C, with 720 hours of salt-spray exposure.
    • Complete-job ready: Delphi includes the necessary accessories for the installation.

    If worn rear lower bushings are the cause of clunking or vague handling, this replaces them to help restore proper location of the control arm.

    Interchange: 537128 · 19311962 · K200522 · MS50492 · JBU1614

    This part cross-references / interchanges with the following part numbers:

    537128, 19311962, K200522, MS50492, JBU1614

    Frequently Asked Questions

    Is this the right HHR control arm bushing for a 2006-2011 Chevrolet HHR?

    Yes, it is cataloged for the rear lower position on the 2006-2011 Chevrolet HHR, and it also fits models such as the 2005-2010 Chevrolet Cobalt and 2007-2010 Pontiac G5. See the "Vehicles it fits" section for the full list.

    Where is this bushing located?

    It is cataloged for the rear lower control arm position on the listed applications.

    What is a suspension control arm bushing?

    It is the cushioning bushing that locates the control arm at its mounting point, isolating vibration and helping the wheel track properly while allowing controlled suspension movement.

    What are signs this bushing may need replacing?

    Signs may include clunking or knocking over bumps, vague or loose handling, and uneven tire wear. Diagnose the cause before replacing, since other suspension parts can produce similar symptoms.

    Does this bushing come with the parts needed to install it?

    Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review

    Related Products

    !