Tighten up your front-end handling with the Delphi control arm, part number TC2541 — a front right lower suspension control arm that locates the wheel to the chassis, pivots on its bushings, and carries an integrated ball joint for steering and suspension travel. It's a direct-fit replacement for the 2001-2005 Volvo V70 and the 2003-2007 Volvo XC70 (see the Buyer's Guide tab for engine-level fitment).
Delphi applies its OE steering and suspension expertise to this aftermarket part:
OE-validated durability: tested to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection help ensure materials match OE specifications.
Consistent build: robot welding for repeatable quality, with ball studs machined to micron tolerances for durability and smooth joint operation.
Corrosion protection: anti-corrosion treatment applied to each part for corrosion prevention and enhanced appearance.
Clunking over bumps, wandering steering, or uneven tire wear can be signs a control arm bushing or ball joint may be worn; if a failed arm is the cause, this replaces it. Have the suspension diagnosed and an alignment performed after installation.
It's a direct-fit front right lower control arm for the 2001-2005 Volvo V70 and the 2003-2007 Volvo XC70. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Is this a V70 control arm or an XC70 control arm?
Both — this Delphi TC2541 is cataloged as the front right lower control arm for the 2001-2005 Volvo V70 and the 2003-2007 Volvo XC70.
What does this control arm do?
It locates the wheel to the chassis, pivots on its bushings through suspension travel, and includes a ball joint that allows the steering knuckle to move.
What are signs my control arm may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to a worn bushing or ball joint. Have the suspension diagnosed to confirm the cause before replacing.
What quality testing does this Delphi control arm receive?
Delphi uses 100% crack and ultrasonic flaw detection, robot welding, ball studs machined to micron tolerances, and anti-corrosion protection, plus -40°C to 120°C and 720-hour salt-spray testing.
Suspension Control ArmDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme...
Suspension Control ArmDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
