Delphi Suspension Control Arm P/N:TC2826
Help keep the wheel located under load with the Delphi control arm TC5206, a front right lower suspension control arm built on Delphi's OE safety technology. This Delphi control arm drops in as a direct-fit replacement for the 2010-2012 Toyota Prius and 2011-2012 Lexus CT200h (see the "Vehicles it fits" section for engine-level detail).
Delphi tests to the extreme for OE performance: parts withstand temperatures below -40 degrees C and over 120 degrees C and endure 720 hours of salt spray, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part. As a control arm, it locates the wheel and provides the pivot for suspension travel; a worn arm or ball stud can produce clunking over bumps and steering wander. If a failed front right lower control arm is the cause, this Delphi lower control arm for the 2010-2012 Toyota Prius replaces it.
Interchange: 102-7737 · 622.44809 · 522-362 · 48068-47050
1027737 · 62244809 · 522362 · 4806847050 · CA74334 · CA74334PR · RK622202 · CMS861031
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi TC5206 control arm fit?
It is a direct-fit replacement for the 2010-2012 Toyota Prius and 2011-2012 Lexus CT200h. Check the "Vehicles it fits" section to confirm your exact vehicle.
Is this a front or rear control arm?
TC5206 is the front right lower control arm. It locates the wheel on that corner and provides the lower pivot for suspension travel.
What are the signs I may need a new lower control arm?
Clunking over bumps, steering wander, uneven tire wear, or a loose feel can be signs a control arm or its ball stud is worn. Have the cause diagnosed before replacing.
Does this control arm include the ball joint?
Its ball studs are machined to micron tolerances for smooth joint operation as part of the arm. Compare against your original and the interchange numbers to confirm the correct configuration.
How is the Delphi control arm built and tested?
It uses robot welding and 100% crack and ultrasonic flaw detection, with ball studs machined to micron tolerances. Delphi tests it below -40C, above 120C, and through 720 hours of salt spray.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.