Delphi Suspension Stabilizer Bar Bushing Kit TD1029W
Delphi Suspension Stabilizer Bar Bushing Kit TD1029W

Front Sway Bar Bushing Kit for 2003-2004 Saab 9-3 - Delphi TD1029W

Be the first to review this product
$35.99
WARNING:California Proposition 65▾
MPN: TD1029W
UPC: 689604338650
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Ask an Expert
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1029W
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1029W
$35.99

Quiet down front-end rattle and keep the front stabilizer bar firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD1029W). It drops in as a direct-fit replacement for the 2003-2004 SAAB 9-3. Front sway bar bushings cradle the stabilizer bar where it mounts to the chassis, letting the bar twist under cornering loads while cushioning it against the frame — as they wear, that connection loosens, so a fresh set helps quiet noise and tighten up the way the bar controls body roll.

  • Designed to OE standards: Delphi applies its OE engineering to its aftermarket steering and suspension portfolio, with extensive dimensional and material analysis for the best OE-to-aftermarket compatibility.
  • Tested to the extreme: validated below -40°C and over 120°C and exposed to 720 hours of salt spray for OE performance.
  • Built for consistent life: manufactured to a repeatable standard so the bushings hold up over the long haul.
  • Manufactured to reduce noise: engineered to help restore the smooth ride of the vehicle.

If worn front stabilizer bar bushings are behind clunking, rattling, or sloppy body roll on your 9-3, this kit replaces them.

Interchange: 24428002 · MS10891

This part cross-references / interchanges with the following part numbers:

24428002, MS10891

Frequently Asked Questions

What does the Delphi TD1029W bushing kit do?

It replaces the front stabilizer bar bushings that hold the sway bar to the chassis, letting the bar twist under cornering loads while cushioning it to reduce noise and help control body roll.

Does this kit fit my vehicle?

It's a direct-fit front replacement for the 2003-2004 SAAB 9-3. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.

Is a stabilizer bar bushing kit the same as a sway bar bushing kit?

Yes. A stabilizer bar bushing kit and a sway bar bushing kit are the same thing — "stabilizer bar" and "sway bar" are two names for the same suspension component.

What are the signs my front sway bar bushings need replacing?

Common signs include clunking or rattling from the front over bumps and more body roll or looser handling in corners. Diagnose the cause before replacing, since other suspension parts can produce similar symptoms.

What part numbers does this kit replace?

It cross-references interchange numbers 24428002 and MS10891.

Related Products

!