Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1634W
$11.99
(You save)
Quiet a clunking, loose-feeling stabilizer bar and keep it firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD1634W. This kit mounts in the rear-to-frame position, cradling the sway bar where it attaches to the frame so it can twist and resist body roll without rattling. It's a direct-fit application for a wide range of BMW models, including the 2006-2011 323I, 2007-2011 328I, 2007-2011 335I, 2009-2011 335D, 2008-2010 528I and 2006-2007 530XI — see the Buyer's Guide tab for the full list and engine-level fitment.
Cracked, dried or worn sway bar bushings can produce clunks or knocking over uneven roads and vague handling — signs this rubber bushing kit may need replacing.
Built to OE standards: designed to OE specifications using Delphi's dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and over 120°C, with exposure to 720 hours of salt spray.
Manufactured for consistent life and to reduce noise.
Ride comfort: the bushings help restore the vehicle's smooth ride.
It installs in the rear-to-frame position, holding the sway bar to the frame so it can resist body roll while pivoting quietly.
What does a sway bar bushing do?
It cushions and locates the stabilizer bar where it attaches to the frame, letting the bar twist to control body roll while limiting rattling and noise.
How do I know if my sway bar bushings are worn?
Clunks or knocking over bumps and vague, loose handling can be signs of cracked or worn bushings. Diagnose the cause before replacing, as other parts can produce similar symptoms.
Will this kit fit my BMW?
It's a direct-fit application for the listed BMW models, such as the 2006-2011 323I, 2007-2011 328I and 2008-2010 528I. Check the Buyer's Guide tab to confirm your exact vehicle.
Has this kit been durability tested?
Yes. Delphi validates it below -40°C and over 120°C and exposes it to 720 hours of salt spray, backed by dimensional and material analysis for OE-level compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1634W
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
Quiet a clunking rear sway bar and keep it precisely located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD935W). This rear kit drops in for a wide range of BMW models, including the...
Quiet down clunks and steady the front sway bar with the Delphi Suspension Stabilizer Bar Bushing Kit TD5755W, a direct-fit replacement for the 2002-2006 Nissan Sentra. These front stabilizer bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
