Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4129W
$14.99
(You save)
Quiet a rattling rear sway bar and keep it properly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4129W. This rear-to-frame stabilizer bar bushing kit cushions the rear stabilizer bar where it mounts to the frame, isolating vibration and limiting bar movement. It's a direct-fit replacement for many vehicles, among them the 1993-1998 Jeep Grand Cherokee, 1984-2001 Jeep Cherokee and 1997-2004 Dodge Dakota — see the Buyer's Guide tab for the full list.
OE-standard design: Delphi bushings are designed to OE standards, drawing on Delphi's OE expertise across its aftermarket steering portfolio.
Extreme-condition tested: validated below -40°C and over 120°C and exposed to 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Consistent life: manufactured for consistent life and to reduce noise.
Smooth ride: designed to help restore the vehicle's smooth ride when worn bushings are the cause.
If worn, dry or cracked stabilizer bar bushings are behind a clunk, rattle or sloppy body roll from the rear, this kit replaces them.
It's the set of bushings that cushion the sway bar where it mounts. This TD4129W kit fits the rear-to-frame position, isolating vibration and limiting bar movement.
Which vehicles does the Delphi TD4129W fit?
It's a direct-fit replacement for many vehicles, among them the 1993-1998 Jeep Grand Cherokee, 1984-2001 Jeep Cherokee and 1997-2004 Dodge Dakota. See the Buyer's Guide tab for the full list.
What are signs my sway bar bushings may need replacing?
Worn, cracked or dry bushings can cause a clunk or rattle over the rear and increased body roll. Have the cause diagnosed, since other suspension parts can produce similar symptoms.
Where does this kit mount?
These bushings mount the rear stabilizer bar to the frame, cushioning that connection to reduce noise and limit unwanted bar movement.
Is this kit tested for durability?
Delphi validates these bushings below -40°C and over 120°C, exposes them to 720 hours of salt spray, and performs dimensional and material analysis for OE-to-aftermarket compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4129W
Quiet front-end rattle and keep the stabilizer bar firmly located to the control arm with the Delphi Suspension Stabilizer Bar Bushing Kit TD4128W. It installs as a direct-fit replacement on many...
Help reduce front-end noise and keep your stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD4053W. This front sway bar bushing kit installs as a...
Keep the front stabilizer bar firmly located and help quiet suspension rattle with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4566W). This front sway bar bushing kit fits many vehicles,...
Quiet the rattle and keep the rear stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4108W). This rear-to-frame stabilizer bar bushing kit installs as a direct-fit...
Keep your MINI's front stabilizer bar located and cushioned against the chassis with the Delphi Suspension Stabilizer Bar Bushing Kit TD1450W. It drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
