Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4149W
$15.99
(You save)
Cut down clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD4149W. It's a direct-fit replacement for the 1995-2005 Dodge Neon, seating the front stabilizer bar to the chassis so the bar can twist and resist body roll as the suspension works. Delphi applies its OE steering and suspension expertise to this aftermarket bushing kit, with parts validated through extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Designed to OE standards: Delphi bushings are engineered to match the original equipment specification.
Consistent life: manufactured for consistent performance over their service life.
Quieter operation: manufactured to help reduce noise from the stabilizer bar mounts.
Smoother ride: Delphi bushings help restore the vehicle's smooth ride.
Tested to the extreme: withstands temperatures below -40°C and over 120°C, and endures 720 hours of salt spray.
If worn front stabilizer bar bushings are the source of your clunking or excess body roll, this kit replaces them. Fits the front position on the listed application.
What is a stabilizer bar bushing kit and what does it do?
It's the set of bushings that hold the front stabilizer (sway) bar to the chassis, letting the bar twist to resist body roll. Worn bushings allow the bar to shift, causing noise and sloppy handling.
Which vehicle does the Delphi TD4149W fit?
It is a direct-fit replacement for the 1995-2005 Dodge Neon. See the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this for the front or rear stabilizer bar?
This kit fits the front stabilizer bar position on the listed application.
What are the signs my stabilizer bar bushings may need replacing?
Common signs include clunking or rattling from the front over bumps and increased body lean in turns. Have the cause diagnosed, since other suspension parts can produce similar symptoms.
How is Delphi's quality validated?
Delphi tests to OE performance, with parts that withstand temperatures below -40°C and over 120°C plus 720 hours of salt spray, backed by extensive dimensional and material analysis.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4149W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
